Viewing all customer Discussions for:

Door & Window

Stamp is 3350, Length is 34", for a Non-Tilt Window. IG5 CMC54.

Need replacement coil spring(s)

Coil cover is1/2 inch thick1-3/4 long1-1/4 wideBreak shoe is 1-3/8 long, 1-1/4 wide1/2 inch coil 9 lbs

Hello, I need help identifying the channel balance and the pivot rod in the attached pictures.

Just need a replacement stop as shown in pictures

Sliding glass door replacement lock and handle

Wondered if you have this part? The extension post that goes in the main frame on the top is broken

Hi - We recently purchased the Certain Teed Pivot Shoe to replace the one that broke..the plastic part had split in half.The opening on the certain teed is not quite big enough for the tab(?), not sure of correct term, to fit snugly in.Please advise, thank you!Dan

Hello, Hope things are going well. Say, can you help me I.D. This balance? It's from an Alcoa window, tilt. Thanks Doug V

Trying to find replacement parts for this window. I don't know much about the window other than that it is part of a pre manufactured home.

Hello. I am hoping to replace the channel balances on two vinyl double hung windows (4 balances total). The channel is stamped 28D and the sash weighs 23 lbs. The replacement balance appears to be the S770-28D. However, the top and bottom connections are not typical and may require a custom order ... (cont.)

Looking for compatible part for United windows sliding door part# 4500-PD roller.

Hello, Would you help me identify this part? I would like to purchase 24 of them. Chris

Door handle broke off and I need a replacement part. House built in 2004.

Hi~ I have simenton casement window that opens from the left and it has to be replaced. Simenton no long has the parts and wonder if you guys could help out. Thank you so much in advance. Maria

OUR CUSTOMER NEEDS A KEEPER FOR HER SLIDING PATIO DOOR. PICTURES ATTACHED OF HER EXISTING HANDLE AND LOCK GUTS.

Need 2 . Need part # to order them

The arm on the crank is about 12 in

The nylon tie bar guide on the crank out window broke. Is there an easy way to replace it?

I need a replacement for the broken stop on the upper channel that the balance uses.