Viewing all customer Discussions for:

Closet

This is a 97-in tall door has a track on top and on the bottom this particular part is for the top rail that has attracted this part hooks into and rolls

I am looking for replacement parts for my wood folding doors. I have 4 door panels and they don't stay closed. Do you have a complete replacement parts kit?

The rollers of my mirror closet door need to be replaced. The plastic wheel is not longer round all around.

Doors are about 8 feet tall and weigh about 50-75lbs each. Looking for non plastic replacement if possible

I am looking for the part that holds the sliding door in the track on the floor.

Hi i need 3 sliding mirtor doors botto tracks. 72 inch wide each. 3x72 inch bottom tracks. I need also the long support black bracket on the middle under the track 3 brackets. Also 6 floor guides.

can I use this wheels 23-222C in a 5024???

Top slide for bifold door. One is broken, trying to find replacement.

Hi can you help have been looking for a while and your site is the only one that seems to have what I need. Have looked at part no 23-041 Mirror Wardrobe Door roller assembly. Ours is a convex roller will this one fit as the housing looks the same as ours. In actual fact it is only the roller whe ... (cont.)

Which track is compatible with the 23-092 roller? The center measurement between the two rails on my current track is 1 5/8". I purchased a track from Lowes and the guard rails on each side were too high and the roller wheel could not reach the rail.

Mirror closet sliding door we need 6 of these if you have or can find please

Looking for two of the pictured gliders. The closer door may be from 1972? When the house was built.

Need to purchase same identical parts. Need info on removing top and bottom rollers from existing closet door.

58 1/2 opening

Need replacement bottom pins and a couple plastic sliders for the bottom rails. Pic1 shows top pivot pin (which I have all of), pic 2 shows bottom of a door, pic 3 shows the one bottom pin and the plastic slider that it snaps into. The rail is at (or just over) 7/16ths inch wide. The pin is 5 1/4 ... (cont.)

Any chance you have this part, please? Thank you. For my Dad.

I want to buy 6 kits Cox 21717 21767 with concave roller, pse inform us avaiability, cost per unit and estiamte time to receive them.ThksDaniel

The stationary pins seem to be OK (although I should probably replace them also) but I need the assemblies for the parts that slide back and forth in the track - both top and bottom are gone. Can you please identify what I need to buy to re-hang these doors? They are quite old and don't match the ne ... (cont.)

Hello. I am looking for replacement upper and lower roller hardware for an old bypass closet door. The door itself is quite thin and the rollers look smaller than the other rollers you have on your website. The bottom piece is 4.25" by .5". Can you help me locate a good match? Thank you. ... (cont.)

Need replacements