Viewing all customer Discussions for:

Closet

Looking for replacement part # 10118. It is the bottom guide for our mirror doors.

What can I use to replace this pivot bracket? Will I need to replace both top bracket so the doors hang properly?

What do I need to fix this?

I'm trying to find the replacement plastic mount because this one is stripped out.

We have a home built in the '70's. Almost all of the closets have 89" metal, bifold doors. The doors vary in width depending on the closet opening, but all are the same design. Since it would be a messy and costly hassle to reconfigure the closets and the openings to change to a "modern" door design ... (cont.)

Hello! We are needing to replace the rollers for one set of closet mirror doors they are the Monarch brand. Below is a picture of the roller that I am needing. Do you sell this product and can it be shipped to me?

Hi I am looking for a replacement part. The plastic part on the top broke in couple of the doors. Do you have this part? And do you know if I can only get the plastic part or I have to replace the whole thing. thank you.

In front of the washroom the washer and dryer room

Thanks... Happy I was able to find replacement parts. This is the piece I need. Can you tell me if this is something you can sell me?

Hi, I submitted an inquiry about 15 minutes ago and then realized I should have included more information. I'm missing the upper and lower pins from bi-fold doors manufactured by Kinkead Industries. The brand is Float-A-Way. The doors are 65" width, 78.5 height. Do you have anything that would work ... (cont.)

We need replacement parts for wood sliding closet doors. Do you have suggestions?

Hi. I need new tracks for the pictured sliding doors. They date from the 80s, and measure 59" wide. Thanks, Ellen

Attached, please find: 1) picture of bottom wheel assembly. There is also a clip that holds the wheel in the track, and 2) cross section of the track. Track was damaged during remodeling. Please make recommendations for replacement. Thank you

Not sure what part this is but I believe it is for spiral balancers.

I am submitting a picture. the part number says: ACME 17-4075

On Part in shows: "CONTRACTORS WARDROBE 10SW11 002"

These rollers have been in the house since 1956. Can't find these anywhere based on my photos do you have anything like this? The medal bracket is flat

I need four of these parts, Home Depot only has something bigger than these. I put a Nickel and a penny to give you an idea of size. Thank you for your hel.

This is a roller hardware for a louvered closet door, and a piece of the roller has broken off. It's manufactured by Grant. It's adjustable, and is marked "3/4" rear and 1 3/8" front. Can you help me?

Top and bottom connector to closet