Viewing all customer Discussions for:

Closet

Im looking for the spacer or bumper that fit the number on the doorss between the top and bottom of the two bi fold metal doors i found one that looks looks like the ones I have but the length is 2" and the ones I have are about 1 1/4" The door pin cap# 21-108 should fit my track ... (cont.)

Hello Please let me know if you have this part and whether only the wheel can be replaced or if I need the entire assembly. Thank You

Hi I am trying to replace this part on a couple of my closet doors. Only identifiable part number is US PAT 3750337 Any help is greatly appreciated.

hello I am in need for pins for a complete bi-fold door and pivot clamps for them The upper pins I have are the same as 21-065. do you think that the pivot clams 21-154 will work for me

I'm interested in replacement similar hardware for soem bifold doors that conceal a desk/closet area. The current hardward resembles this item (WARDROBE DOOR ROLLER ASSEMBLY, 7/8 DIA.) but I cannot fiture out how to remove the door from the track. Do you have instructions or advice for removing a ... (cont.)

Hello. Roller is 3/16 Horizontal part of bracket is 1" Vertical part of bracket is 2 1/8" For a front rolling door

Nylon wheels have lost their edges. Looking to replace wheels. Is the wheel assembly available so I don't have to punch a rivet or drill anything? It popped out easily, hoping to pop one right back in. No markings found.

saw your excellent Youtube video on closet door tracks. I've got a question I'm hoping you can help me with. The photo below is the low profile track to be installed on my basement floor. One side will be unfinished concrete and the other will be underpad & carpet. How should the track be install ... (cont.)

This white plastic wheel is clipped into the TOP frame of a patio glass sliding door. It appears to simply maintain the door in the upper track without a "wobble or lift" when you slide the door open and closed. My guess is this is about a 20 year old sliding glass door.

I'd like to know what this part is because it looks broken .

I'm looking for Stanley mirror closet door assembly #3750337. Photo attached. Please advise. Thank you

hi, this part is used to secure top of the bi-fold door to the top track pin. Plastic piece is rotated and clicks, locking top bracket to the pin. Bracket is 2 1/4 " long.

the number 4212 is engraved in here. the name stanley is on the blue flag. it looks like it might be product code 23-041. the measurements seemed pretty close. but i noted that mine is plastic (the black part) and i don't see the blue flag on yours. anyway, was hoping you could confirm that ... (cont.)

I would like to replace these wheels for the bottom of mirror sliding doors. This is the bottom. Each door has 2 each (for a total of 4). They slide into a housing on the doors. Also, the top of the doors have a rubber piece that it would be nice to replace if possible.

I need to replace pin caps on several bifold doors. The measurements are shown in the photo but are as follows: Pin 5/16" OD Pin length 5 1/4 inch Pin cap hub 3/8" OD Pin cap flange 1/2" OD Thank you!

It is approximately 2" long x 5/8" wide and the pin is about a 1/2" high. No markings

Need top guide . The plastic guide broke .

I'm looking for a replacement for this track that i sent you. I think i probably need replacement wheels as well.

Please help me find the correct part for my mirrored sliding glass door.Here is the part I need. Thank you.Bob T.

Attached is a photo of a bi-fold door guide used in my house that was built circa 1980. Does anyone know if this type of guide is still available?Thanks in advance for your help.Tom