Viewing all customer Discussions for:

Closet

Need this part

I have an old metal bi-fold door that is missing some parts but in overall good condition. The pivot rod clamp, pictured, I believe matches your part number 21-154. Also, the bottom guide pin, pictured, matches your part number 21-001 and 21-005. Not sure which one is the right one. ... (cont.)

The door has a Stanley Works label on it. I am looking to replace the floor track rail shown but do not need to replace the wheel mechanism. The track is 3 3/8 inches wide and 69 inches long.

Lower Nylon wheel assembly broke off CW bi fold mirror

Closet mirror sliding doors with convex wheel with pins on either side of the wheel. The wheel is approximately 1.5" in diameter. See attached pics.

Good Morning! I need to know which will be replacement part for above bi-fold door top and bottom . Thanks

Hi, I'm looking to replace this 5 foot track to this Stanley mirror closet door because the back door won't slide over the track. Any insight would be appreciated. Thanks!

I think I found the to one on your web site and sent you a pic of it but want to confirm for both top and bottom.

-On the top left picture is the door brand. -on the top right pic is the folding doors. -on middle left Pic si the bottom hardware. -On middle right pic is the top hardware. -on bottom pic is the broken top hardware part taken off the door.

I am looking for a Stanley Top Mirrored Sliding Closet Door guide for corner mounting as pictured. It has a Stanley U.S. PAT 3750337 number on the metal part of the slider and on the plastic part a U.S. PAT 4819297 number. I am holding the broken part in 2 photos, and the close up photo has the ful ... (cont.)

Hi Please see photos above. One door lower wheels has sheared. Do you recognise / stock the parts? We are in the UK, and the doors are a 4 set mirrored which were in our property when we purchased it 18 years ago. Fingers (and toes and anything else) crossed.

I need a pivot pin replacement since the spring is missing. I have included a photo of the inoperable pin and one that is working. It appears the spring is missing as well as the retaining washer. I have also included a photo of all the markings on the door. Thanks.

Hi I have a few older metal bifold doors that were installed with the pins and a track on the top and bottom. I'd like to reinstall them with new pins and new track on the top only and use a corner jamb if possible. What parts would replace what I have? The holes in the doors for the pins are 5/16"T ... (cont.)

Need to replace the track & wheels on our sliding Monarch Mirror doors. Looking on your website, it appears that #23-240 48" track would work along with #23-199 wheels. Am I correct? The doors have been in place since 1972

The doors drop down when opening; when in the closed position, I can lift the doors up, and they seem to "clip" back into place. I know there is no bottom track, but there is also no support at the bottom pin at the wall jamb; which I'm certain is part of the issue. Please advise on all pertinent pa ... (cont.)

white wheel 1.5 inches, metal part 1.5 inches, wheel assembly 3 inched top to bottom including wheel.

Hello. I am looking to replace the bottom track on my mirrored closet doors. The current track is 3.5 inches wide and 60 inches long. Do you have any that width? It appears your bottom tracks are about an inch too narrow for me, although the upper guides you sell look like they would match perfectly ... (cont.)

Trying to redo old bifold doors need all hardware for both sides. Two panels each side (4 total)

Hello. I would like to please know what material this mirror door pull handle Product Code: 22-022 is made of. Is it plastic or metal?

N