Viewing all customer Discussions for:

Closet

Hi, I need 1 door slider pictured as attachment for a bypass closet door. It is 4.5 inches in length and 2 inches wide. Do you have this? If so, I need to order it. Thanks, Laura

The sliding doors that I have contain a roller at the bottom and top. A photo is attached for each type. What part numbers should I use to purchase 2 of each type? Thanks John

I recently purchased sliding door track 23-240 (48") from you. The entire track width is good, but it is considerably narrower than the original track. I do not know how to align this with the upper track to be sure doors will hang correctly - vertically level. The upper mounting is a total of 3-1/2 ... (cont.)

Hello I have these 96" bi-fold metal doors that I want to continue to use. But no one carries the parts. They are same design top n bottom pivot side and opening side. I am unsure if what is in the only picture part whether is is actual original or not Top pivot has a plastic cap set in. The ... (cont.)

Used on bifold closet door to anchor door close to the wall

Hello I have 10 pocket doors with low quality rollers. (see roller on left) I am looking for a good quality replacement. The one I bought online(one on the right) does not fit the track. Can you help? Randal

Do you sell a replacement for this part? Thanks,

I'm looking for a roller for sliding closet door. (Top mount) It's Lawrence Brothers No. 54. Thanks, Cory

Hello, How do I remove mirrored bi-fold doors with the corner block 17-4405? Thank you Tom M

I'd like to replace the bottom convex door wheel. One of the pieces is broken. Is there a suitable replacement?

Hello, Do you have any replacement wheels like these. Rivets are worn and one is actually broken. Thank You Sal

Part number is 4010-2. Believe it is Acme. Here's a pic for you to take a look at. We're actually missing one whole right side assembly like the detached one in the picture. Any thoughts?

I need two 6 ft lengths of bypass closet door track. I don

Hello, I would like to replace the rails pictured.They are 4' 8" long x 2 3/4" wide. I think they are pretty standard type rails. I will need two (2) pieces of the above length and one (1) piece 9' 9" long. I will have to verify the exact length of each piece when I order. Are your rails po ... (cont.)

My Cox rollers have the same number on them but they don't look the same. What parts should I order

Slimfold, Category II, 352-216-3049 Aj. Need Rollers for doors

Dear vendor, Would you please take a look at the attached picture and tell me if you have this in stock or recommend me anything similar for my closet door. Thank you so much for your time. Christine

It appears that these doors were already make shift to me. I originally thought the nylon was threaded but it just appears that the bolt eventually pushed through the door pin cap.

Trying to find a match to my current sliding closet door roller assembly. It's top mounted. The roller wheel\bearing is worn out - and causes the door to slide loudly, and bumpy. Hoping you can look at the pictures I sent to let me know if it's available. Thanks!

Good Morning, Can't find the replacement piece at the Stanley/National Hardware site. Markings include STANLEY, and 17-4116 on the white plastic piece.The black wheels are composite plastic/rubber and are removable/replaceable themselves.