Viewing all customer Discussions for:

Closet

We just moved into a home and when the painters did the walls, they took down our mirrored metal bifold doors and we are having problems putting them back up. The tracks were bent but I've been able to mostly re-align them. The biggest problem is tightening the stationary bracket that holds the uppe ... (cont.)

Attached are photos of the top of the metal bi-fold pivot. I also needs some of the threaded parts for the bottom pivot. At minimum, I need (4) springs, caps, and the best device to hold in the pin. The pin is 5/16 (.310) x 5 1/4" long. I was looking at parts 21-065, 21-001, 21-007, and 21-154? ... (cont.)

I need the roller piece that fits in the device shown in the picture. It has a part number of W8025 stamped on it. From Contractors Wardrobe. Thanks, Larry

We are looking for a replacement part for a BenchMark Bifold closet door bottom track. Here is a picture of the track itself along with the pin.

Which top roller guide will fit in the bifold track 23-453

I need 2 of these

I am going crazy trying to find a replacement part for this. Home Depot - Lowes - US Patent Office (#4850) etc Please see attached pictures. Thanks in advance for any help you can provide, Curt

Please help me in identifying this hardware- Scott

Hello, Do you sell this item?

These are the best pictures I could get of

how wide is these tracks. 3inchs I hope?

Dear Sir or Madam, I have an older wardrobe made by Stanley ACME where one wheel of the sliding mirror door top roller is broken. Now I was searching on your webpage and have found the part with the code 23-222B. My top roller has 3 wheels and this one has only two. Is it possible to replace my ... (cont.)

I need the a replacement for the part shown. The cam gears in the adjustment are stripped out and will not allow me to raise the door.

Hi There! I have been searching for the correct hardware for my mirrored closet doors, have purchased a couple different sets and they have not been the right ones. Apparently I need ones that you do not screw into the frame. I have seen ones on your site that look similar, but the adjustable scr ... (cont.)

i need the roller insert for this assembly. It is 1 1/2" wide. What is the part number i need to order?

1/4inch inside

Not sure what part to order. I can't see any markings on my current part. Thanks

Hello Customer care, I am looking for a Sliding Glass Door Bottom Track. I found your item/product code 23-242. It is similar to mine, see pictures attached. Do you know if this will work. My door have bottom convex rollers.

Hi I'm trying to build my own closet doors of wood. It'll be small roughly 20x60 each door. Most hardware I've seen mounts the doors on a top track screwed to the header. However I'm thinking I want to put these on a bottom roller track so weight is on the floor. Can you help assist me to find the r ... (cont.)

i have a set of Benchmark Bi-Fold doors in my pantry. i just had them painted and replaced all the hardware 21-044 and 21-002. the doors open and close now very smoothly however the right side wond clsoe completely ? i have tried several adjustments and there is a slight gap between the doors so t ... (cont.)