Viewing all customer Discussions for:

Closet

Track insert for safety backed mirror door Ansiz97-1-1984 Cgsb12-5-m86 type c

I don't have any markings on the parts. I have hired a contractor who is doing a remodeling project. We have not seen any railings that might fit these doors. The doors have concave runners (IMG_0481). I'm wondering if you have a 72" track that these wheels will work on? If these rollers don't work ... (cont.)

Upper closet door rollers acme brand

Is the bottom track made of steel or nylon?

I am sending the picture of the track and also the wheels. I have not opened the closet door to remove wheels. It looks like concave track, where the wheels run over the track. My house was constructed during 1984 and it was put at that time. Can you suggest what product i should use to replace it ... (cont.)

Looking to update the hardware for my old metal closet door. I have tried to use WD 40 and other lubricants to try to get the door sliding more cleanly, but I ultimately think all of the hardware could use replacing. I cannot seem to find hardware like this anywhere I look though. Help identifying i ... (cont.)

Recently purchased a home built in 1998. There are sliding mirrored bypass closet doors in the master bath. The bottom track is rusted and unsightly. Not sure just how to remove the doors from the track. Both upper and lower hardware bear the same number: DSH 20121, but the upper hardware has the ro ... (cont.)

Our Master bedroom has COX by-pass sliding mirror closet doors. The span of the entrance is 90 inches. Each panel is 48 & 3/4 inches. The white floor track is bent and scratched. The rollers are concave (21-717 stamped on the mechanism) and are chipped. They do not ride properly in the track. T ... (cont.)

The pictures are the sliding part of the doors, There is no rollers. Need a part that can replace the one in the pictures. It swivels back and forth, want to replace all 4 of them with a part that has rollers. The piece that screws to the door frame it is #6. Please advise as to what part you may ... (cont.)

I have a right and left bi-fold doors need new hardware I have the top rail but need replacement parts any idea who made these the originals are about 28 years old

Look for Stanley sliding closet top door glideThis is the label on backside of door thanks

Does the 23-222B come in sets or as one piece

Looking for a replacement for these. I believe the original is discontinued.

29-708 29 UP

Is this part offered in a bright zinc finish still? Thank you.

Looking for replacement nylon roller for a mirror bifold closet door. Pictures of a roller/pivot cap attached along with the end of the track. Can't find anything online with these dimensions. Doors / hardware have no manufacturer info on them:( Thank you, Pete

Need 4 of these and 4 that have 1/2" offset

As you can see, the bottom track is beaten up a bit. I'd like to replace it but I'm not sure where I can find a track that works with the concave rollers I have. I haven't been able to find this exact bottom track. Maybe they don't make them anymore. I have laminate floors and would prefer to not cu ... (cont.)

Is the castor piece removable from the housing? We have a Charmac mirror meta slider from the 90"s Thanks

The attached is on the rear door of my closet and keeps separating from what ever screw I put in. Would your 23-010 be the correct replacement for the current bracket? Also would your 23-200 be the correct door guide for the 1 1/2 " doors. Thank you