Viewing all customer Discussions for:

Drawer & Cabinet

Is that the correct measurement 3 1/32" for the width? It looks more like 1 1/32". I'm looking for a replacement like the ones in the attached picture. Do you think this one will work?

I need file rails for the file drawer. They measure 1" x 12" long by 1/8" thick

I attached a picture of the top of the doors with the bracket installed, then the bottom where it was removed. The bottom one had the "L" part of the bracket snap in half. Thanks for your help trying to find a replacement!

This nails on the bottom of the drawer so it slides easier

Hi / I am missing 5 pulls from a dining room set that may be Thomasville. The set is about 70 years old. Let me know if you have these available.Thanks!Maryanna

Party is 1 7/8 wide 1 1/2 long also need the matching slide piece.

No parts number. Trying to find a replacement

These hinges do not force the cabinet to close when the cabinet is within 2or 3 inches of closing. Do you have matching ones that will automatically close at the end of closing?

Looking for 9 of these. Thomasville. 3-1/2" center to center.

Hello,It's possible that you might be looking for something like our 32-125 drawer stop. Take a look at the video below and see what you think.

product is made by Kenlin and shows you carry product made by Kenlin such as numbers 32-081 Kenlin Drawer Socket and 32-076 Kenlin Case Runner what I need are the corner track guide Photos attached. if there is a replacement we can use if this is not available, please advise. thank you for your hel ... (cont.)

I am in search of two handles to replace from a drexel studio dresser.

Please take a look at the attached photos and let me know if you carry this part. The replacement parts Swisco sent are too large for my application. I ordered item # 32-031 (Rear Drawer guide.) The problem is that the broken guide is smaller than the replacement sent. Please see photos. Please let ... (cont.)

Hello, I am looking for left and right replacement mounting brackets, I am not able to screw bracket into back wall as it is press wood and to thin, I am looking for press in pin design. thanks

Enclosed pictures show the broken "male clip" which secures the track. The broke "male clip" snaps into the back plate which is secured to the back wall of the cabinet. Do you have a replacement part? Thank You.

european style drawer slide rear bracket stamped 60.2101 top and bottom inside measurement is 5/16". The x shaped piece in the track area is removable and is acting as spacer as the drawer track stops at it.

I'm looking for the above part, which is located on the inside back of our kitchen cabinet. I would like a couple right side brackets if you have them . Thanks

I am looking for a brushed nickel hinge to exactly replace the pictured hinge on 15 cabinet doors.

Drawer track socket slide bracket support rear mounting Bottom Side-Mount Plastic Rear Left and Right The bottom plastic of the support is broken on both sides of drawer. We can find no markings or numbers on it.

6827 3340, 81, made in w. germanyHome built in 1979, most hinges breaking--doors will not stay closed