Viewing all customer Discussions for:

Drawer & Cabinet

looking for these drawer slide rear supports.there are no markings on them and not sure of the cabinet manufacturer.steve

We bought our bedroom set in 2003 or 2004 at JC Penny. It is the Cheis Madden Home Collection. One of the pulls broke.

Trying to find a replacement piece for opposite side which is missing. Any suggestions?

Do you have the replacement plastic parts that go in the back end of the drawer and the front of the dresser base? I believe what I need is the SWISCO product 32-053. I do not have the flange on the one end.

Kitchen cabinet brackets for sliding shelves. House built 1991

Is there a metal replacement for this. These plastic ones keep breaking. I have replaced the same one twice in less than 4 months????

The drawers slides were factory installed by Merillat the cabinet manufacturer. I need to move the drawer up higher in the cabinet. I can not get the slide to release from the socket nor can I unscrew the socket from the back wall of the cabinet. I removed one slide by bending it and finally pulling ... (cont.)

This drawer stop is from an antique dresser that was damaged from a move. This part is approximately 2 inches long and 1 1/2 inches wide and sits at the end of the slider stitched to the drawer.

I need 3 sets of these. Been all over. Other 3/8" insets do not line up. Cant move mount holes because of other cabinets

Can?t find replacement hardware for drawer in 5/8? roller size. Ordered wrong parts so far. Any help would be appriated.

Can you please provide the missing vertical dimension on my attached markup of your photo of the #32-011 drawer glide? Thanks.

The Mepla 9M 348.258.00.32 cabinet hinge shown above broke and I was wondering if you guys carried a replacement one. Thank you.

Hello...looking for this style drawer stop...thank you

I have not been able to locate a back plate with this shape. This back plate has a notch in the front that acts as a stop for the glide. The rear of the plate is 2 1/4" tall. From the back to the front of the plate, the measurement is 2 1/4". The glide opening is 1 inch high and has a slig ... (cont.)

I need part 346DR for the right bottom back of drawer where the wheel fell off. The pictures are blurry but the number is definitely 346. I included a photo of the left side which has the wheel. Is this part still available?

This is for my kitchen cabinet bottom drawer left side.Do you have anything that might work for me? inside the part there is a number it is:471037

I'm trying to find replacement brackets for my cabinets. The are about 1 1/4 wide where the rail connects and about 2 1/2 long. I've attached a few photos. Let me know if you have anything like this. Thanks Tom

I am looking for replacement rollers for drawers. they are riveted on and they are 15/16" od. and appears to be a 5/16" shaft.I cannot get pictures to load. I can send them to an email address

This part attaches to a metal bracket mounted on the back wall of the opening. It snaps into the metal bracket. Need just one to replace this broken piece. If you don't carry this can you supply me with the manufacturer or a distributor? Thanks, Ron

I have St. Charles metal cabinets and I need to replace the nylon roller in one of the drawers. It measures 1 inch in diameter and is about 1/4 inch thick. Do you carry a replacement?