Viewing all customer Discussions for:

Drawer & Cabinet

I need to replace kitchen cabinet drawer slides for 2 large drawers that have a built in lip on the drawer sides. The existing slides mounted to the inside of the cabinet are 19 5/8" in length, but are only 1 5/16" wide at the end with the wheel.The projection of this end is 1/2", but the wheel is b ... (cont.)

Looking for part see attached photo. This is from an old cardell cabinet.

The rear adapter bracket I have broke. I cannot find a replacement in the size I need. The part number of the broken one is 6600. The size I have is one inch by a quarter inch. Everything I have found is just a little to small. The wheel on the side of my drawer will not fit into the smaller one. Th ... (cont.)

Need a new rear mounting bracket For a self closing drawer in a cabinet. The mounting bracket is slightly upright To fit the slide which is bent down into the bracket... this allows the drawer to self close ..

Do you have a replacement for this. My track is a u shape at the back it looks like.

Looking closely at parts here is the full description I could get from them; BLUM 701750 01 175H 710 02.01 cabinet latch hinge set

G*grass right 77003

I bought the bedroom furniture from Oasis Bedroom Furniture Store which has since gone out of business. As you can see from the picture the plastic brackets have broken and I need to get replacements. The rail itself is OK. Do you have these parts? If not, do you have any idea where I co ... (cont.)

Hello- This piece holds the bar to the wall for a kitchen drawer. The broken one that I need is on the right side.

Can I replace the loose roller which is causing the door to jam or do I have to replace the entire track set?

It appears to be a 1" OD by 1/4+" wide with a 1/4" hole ID that does not go all the way through, thus keeping the wheel from moving too far to the outside and providing a slide to keep the drawer aligned. I think it is made of nylon or hard plastic.

We have bought at least 2 pairs of 3/8" x 3 15/16" x 7/8" of the bottom brackets and they keep breaking. What is the problem?

I am looking for replacement handles for an antique dresser. The photo is a sample of one , it is missing the round portion on one side. The round piece is actually a separate piece the handle fits in a hole allowing it to swing.

I own 3 dressers that have the Kenlin drawer socket (32-081) & many of them are broken & need to be replaced but I can't decide if I should get the heavy duty drawer socket (32-082) vs the regular ones that came with my furniture. Your website says that both of these are interchangeable. so I assum ... (cont.)

I've ordered other things from you before and worked very well. Hope you have an exact replacement for this. Under one attachment flange is B-6. Under the other flange is 698.256 and 53.00. If not exact replacement, your best recommendation? Thanks, Jack

Trying to locate this part (or comparable). It came off of a kitchen cabinet. It's marked with Amerock and 502474 and 1 1/4"OL

This piece is screwed into the back of the wood cabinet door frame to hold glass insert. It's approximately 1" long and 1/2" across the widest area. The part that extends and presses against the glass is about 1/4". Thanks for any information you can provide.

This drawer slide is a Grass America brand. The installed photo is the left bracket but the right is the broken one. The G* and "RC" are stamped on the slide itself. No markings on the bracket other than "right" The house was built in the 80s so that may give you a timeline.

We need just the plastic end brackets... they have cracked so the drawer keeps slipping off the track...

Need to replace this but don