Viewing all customer Discussions for:

Drawer & Cabinet

This is the picture of the track. I need the back guide. It has to be at least one inch that the track would fit into. Thank you so much for your help.

If I am facing the drawer the right socket broke. H1012 is a number on the socket.

I recently ordered replacement parts for my kitchen cabinets that I thought were correct. What I need are two sets of unigrass 6600 brackets that are 22 and 7/16 inches long metal pieces, including the wheel. What I received were metal parts that are 21 and 11/16 inches long including the wheel. Can ... (cont.)

I live in a mobile home and was looking at the glides thinking they might work on my drawers? They look very similar and I saw another picture of the same use but you had another number for it how do I get to it to check it out before ordering this one

I am looking to replace these for my kitchen drawer. I've tried local hardware stores but no one carries them.

Is this product the piece that fits into the end of the metal glide? Then this piece on the glide slides into the socket??

Markings - mepla, high point, USA. 600.010.02.00 Base- 1 inch wide, 2 1/2 inches long, 1/8 thick Socket- 2 1/4 inches long, inside socket 1 1/8 inches, outside 7/8 inches Arm- 21 1/2 inches overall, 1 inch wide, front lip 1/8 inch, bottom of lip to base 3/4 inches

I can not find any names or numbers on existing pieces. Drawers are probably at least 20 years old. The back plate for the center glide broke. Looking for a replacement. The closest thing I could find on your site is the "Rear drawer track socket 32-002" however if you look at attached photos, the 1 ... (cont.)

The side drawer bracket cracked looking to replace part.

Do these come with screws?

this is a two part bracket first part number is h-104 that I can find second part that is broken is part# h1043 wich slides into h104 supports a glide for a trash can cardell was the cabinet company

Hi- My kitchen drawers are made with Unigrass 6000 epoxy coated slides. The drawer side has the slide integrated into it. The attached photos show the uninstalled cabinet slide, the broken (right side) part that I need to replace and the unbroken left side installed. The cabinets were built ... (cont.)

Patent 2857233

I have a customer who needs a few drawers repaired. They have the older monorail system drawer track roller set up like your 32-040 and 32-041. As far as I can tell all I need is the replacement rear mount drawer sockets. I actually do not want the original type rear brackets; I want something th ... (cont.)

I need a plastic rear mounting bracket for a kitchen drawer slide. the drawer has a single track slide, with wheel attached to the back of drawer and simple rollers at front of drawer opening. the only identifier is pat pend. number on metal track and that is 3.352.617. If that exact part is not ava ... (cont.)

One side of our top cabinet drawer has broke. Need to replace. I order 32-012 but it is 3/8" to 1/2" too long. Also, the back side of the broken piece looks to be glued to cabinet back, not screwed in. Any ideas how to take the old piece off when replacing with new?

Looking to purchase a dozen of theses parts.

I need to replace several rear mount brackets - the bracket is stamped 6600 with number '8' and 'G'. I have been desperately trying to locate this particular bracket because the opening is a little larger than most of the other ones. Hope you have them. Thanks for your help. r

Kitchen drawer rear center plastic guide, manufacturer unknown, circa 1980, see photos

I went on the internet in search of these little plastic 3/4