Viewing all customer Discussions for:

Lavatory

Recently I purchased the 30" shower door bottom sweep with a black bottom sweep. The black piece is slightly taller (say 1/8") than the previous sweep. Do you have a sweep (30") that is about 1/8"less tall than the standard sweep and will fit in the existing grove? If not, is it advisable to shear-o ... (cont.)

Hi, My name is Jim, I came across your website and thought you might be able to help me in locating a replacement for my shower door roller. Here is what it looks like:

10-153 side view is it flat on the long side? do u have similar for 3/8" glass

I'm looking for the original sweep. The t-gap measures 5/16 inches horizontally. .I installed your 10-325 drip rail but the sweep wouldn't allow the door to shut. Not useable. Any help would he appreciated.

chk3002-0106(pk06596E)

Hi, My shower door bottom plastic rail broken need to replace. Could you let me know if your company sell this part or what kind produce and replace it. Thanks,

Our house is KHOV home. I need to replace shower door roller. Any help will be great.

Do I have to dismantle the sliding door or can I take the top frame off the sliding door?

Shower door roller

this part is worn to a point where the sliding doors the inner sliding door goes into the bathtub area creating a dangerous situations this plastic parts is secured by 2 screws and holds the door onto the bottom part of the door frame.!!!

Could you advise me of this part that I need? It is a shower roller with a groove of slot. Thanks, Dolf

Hi, I have a hanger like this: Frameless-Shower-Hanger/pd/Lavatory-Replacement-Hardware/10-153 what would be the right screw and nut set for it? Pls advise. Thank you!

I have a drip rail that is missing on my shower door in the house I just moved in to. It is 25" long, has two screws, and the door swings out. Would Product Code: 10-324 work for me, or do I need to go a different direction?

Do you need to drill a hole in the aluminum so the pin could go in through the aluminum? Does the pin go through the aluminum? To be clear does the pin go through the plastic on one side then through the aluminum then through the plastic square on the other side? Thanks for any help you can give me. ... (cont.)

Step 1: Remove the old shower-door guide. I can't. Detaching it from the DOOR was duck soup. Getting it out of the groove appears to be impossible. It would APPEAR that the originals were slid onto the bottom track with the end(s) of the track free. Now, of course, the track is sealed to the tu ... (cont.)

Greetings, looking to replace the sweep from the attached photos. The piece is approx 21.5" long. It looks like it was attached with double sided tape and the screws held the drip trim piece in place. Thanks, Bret

I'm trying to find a 3/8" height glazing for a 1/8" glass. I have a sliding/bypass shower door and has been so difficult to find the right size glazing.Hopefully you will have the size I'm looking for. thanks in advance

what is the distance between the drilled holes (center to center) on the part 10-325. mine is 22 3/4"

What screw P/N is used on P/N 10-138 handle? I would like to replace my current screws as well.

I am looking for a replacement for this broken glass shower door sweep. It is approximately 23.5" long, with two screw holes, approximately 17.5" apart. Do you have anything that matches this configuration?