Viewing all customer Discussions for:

Other

Hello, I am looking for this assembely. My cell phone number is 608-558-0915 if we need to discuss further. Thank you very much for your help!

Do you have a left and right replac ment?

I have two lower double hung Alside windows manufactured in April 2021 where one or both of the metal part within the shoe is broken. On one window, both the left and right metal part is broken. On the other window, only one of the metal parts is broken. This is not allowing the window to stay in ... (cont.)

I have ordered this from you in the past -can't find the message. Do you have this part? It's 1 3/4 approx wide and 31 1/2 length across.

I also have 26-4 3SI RJ

Stamped 17 3 EV CMC 2, 18" metal only. Both plastic ends are broken and one pulls end. Left side of window has a pull out clip on it the other does not. I need new parts and a bit of guidance to put it back in. ?

I'm looking to replace the rollers on my sliding glass door. The text on the roller reads "Product of Del Mar Eng Co, Long Beach CA PAT 3670357.

We are looking for bottom part that is attached to the cabinet that roller part that is attached to the drawer slides into.it is 23 1/4" long. The replacement sets have all of the slide pieces at the same length. The lenthos the slide pc on the drawer itself is 21 1/2ish

25$

this is a 2001 install slider

Need top and bottom hinge parts for casement window

I do not see a part # but I found a couple #'s on the broken springs. One shows a 5 the other shows a 6. I am looking for the entire part including the housing and tilt mechanism. Thanx for this site!

Replacing various red tip spiral balance on my investment property

Looking for replacement drawer hardware in the sides. The rolling ball has broken off.

Embossed on the face of the balancer - 11600-17 & D787#27 3-87. Please advise what replacement balancer number would be an appropriate replacement.

3/8 diameter. looks like white tip (discolored from grease) first sash 29 inch long. 16 lbs. second sash 29 inch long. 20 lbs. 3rd sash 17 inch long. 12 lbs.

I am looking for a set of these, left and right. Mine are stripped out. Do they make these more durable?

I'm not completely sure which balance spring model would be an exact fit. The string on the pulley assembly snapped in half and I'd like to replace both sides.

Roughly 1/2 inch thick, 1" 1/4 wide and 1" 1/2 tall

Just need the handle