Viewing all customer Discussions for:

Other

Looking for weatherstripping for Alliance windows.

Bottom insert vinyl window track

I need the round pieces that enable the window to slide down and then the pieces that pivot the window out have broken off a bit on four of the windows

Hi, I am in need of two balancers with Label 22 5 BW CMC 2 The metal is 23" long. Matched the PGT types you have previously sent, Thank you,Roger

Hello, my window tilts are all broken, as you can see in the picture latch3.jpg I am looking to replace these pieces Let me know if you need anymore information to identify this part Thank you! Jesse

Hi,Looking for the correct replacement for this Truth operator. Both bars measure 5", window opens to the right when viewed from inside.holes are 5" apart as well.Hope you can help,Thanks!Brad

I have matched my balance to either 380 or 385 but how do I determine 380 or 385 when the old balance plastic has sheared off

Here is the windows details: Windows MFR: PHP-28 A-L-I VALIDATOR Series: 810S Type: Single Hung The marking on the Channel Balancer is: 25 3 DX CMC 11 The length of the metal piece is: 26 inches Attached are photos of the balancer Thanks, Jim

Casement Window Dual Arm Operator EntryGard Entry Gard Truth 31539 40753 U.S. PAT. 4,241,541 CAN. PAT. 350,432 PAT. 1982

I believe this is broken. I need replacement. There is not identification. Roughly 1/2" thick, 2" high, 1 1/4" wide. I need a spiral balance for this as well with charging tool kit.

I need a replacement lock can you identify this part and handle. It's from the early 80s.

I have rebuilt the windows I need the locking tabs to go on the window itself on the frame of the window

height=3cm width=2cm wheel diameter=3cm side=about 3cm , metal wheel

the metal channel is 11 1/2" long. Stamp is printed 11 3 BSI RR. I have one balance but if it works better to replace both then I would like 2 please

Hi ,Need your help. Please review the attached pics of the window lock latch and a window lock keeper with dimensions and please recommend a the correct the part number with a Swisco link.Please let me know if you have any questions.Thank you Alok

Hi, can you help me find replacement parts for these damaged parts? Thank you, for all your help.

I'm looking for this plastic part that locks a awning window. It is located on the window frame and there is one on each side. It actually snaps in place. I'm just looking for a part number etc. so I can buy it. Thank you, John

Channel Length= 26 3/8" Balancer stamped 26 4 unsure of window manufacturer. my best guess would be Pella Windows. I will Need 2 balancers.

Markings -- 23 4 AQ CALDWELL Channel is 24" long ( no plastic )

Help finding part.