Viewing all customer Discussions for:

Other

Would you please let me know which one I should order? Thank you.

I have this part

I am looking for replacement mirror door rollers. Top rollers have broken as shown in photos. Only identifying marking is number 4050ThanksTim

One of my handles broke off my garden window to open window. I attached photos of the broken piece. The hole it goes into and the one that is still working. To me part #39-226 male roto folding handle looks like it is correct replacement handle. Do you agree?

Hi! I am looking for this piece. Specifically the "holder" of the vent latch. This is on a MI vinyl window.

Hi Looking for pivot shoe for my simonton window appx 15 yrs old?? Is it possible you can tell me the part number? Thank you!!!

Window Balance is 1.25" wide, 2" long (excluding the coil. Screw in coil is 1/2" wide and 9 pounds.

25 5 hm5 cmc 8

The attached photo shows what I ordered incorrectly (red X over the item). The other side shows what I really wanted. My bad.

Hi. I've attached three pics. Two are of a window that is in good working order. The third is of a window where the top right hinge falls out of the track. I'm not sure if a new hinge is required, a new track or both. Thoughts? Thanks, Marco

This piece was found at the top of th sliding window, looks like it is damaged.

Looking for window cranks for alside windows in hand shown and in opposite. Windows installed in 2019.

This is an older jalousy operator that I'm having a hard time finding. It has "1400 Series stamped into the body.

Hi,I am replacing my balancers. They measure 26'', and have a "2530" mark on it. Thanks,Yubo

Hi there My son had a broken window so the hubby took out bottom to have glass replaced. When he did he said he snapped something, my guess is those pins. Now the glass is fixed but the window can't be used (opened & closed) without falling out. These are the springs that were in the side tracks. ... (cont.)

I want both left and right replacements for our Caldwell Side Load Channel Balances along with 2 replacement take out clips. The only marking I can read is "Caldwell 26 4 AR" on the broken balance. The 26" reads along the metal rail only. The window is non-tilt. The rail measures 1/2" width on the t ... (cont.)

Good afternoon! I need help identifying the part(s) for this broken crank. The photo of the window crank was submitted by a tenant, so in order to get additional photos, I would need permission to send somebody back in. I am hoping to be able to get an identification from these photos. Thank you,Fai ... (cont.)

Looking for replacement tilt latches (left and right) for windows labelled 8501B, Series 8500/8660, Mfr. SIL-1, A.L.I. Validator. Would you be able to confirm that your 26-266 and 26-267 are the correct parts? Also, would you have replacement locks for that model window, and what would your P/N be ... (cont.)

Hello Tech Support,Looking for this Anderson casement window operator. The arm length is ~ 13 1/4 inches from the crank pivot point to the pivot point on the slide shuttle on the window frame.Also looking for replacement patio door roller assembly shown too.Thanks Paul

No markings visible on door, side glass, or any etchings in glass. Need to replace seals Photos included Thanks, Ed