Viewing all customer Discussions for:

Other

I am looking for door pivot , for a shower door 2004 fully tempered ANSI Z97

Hoping you have a couple of channel balances for a small bathroom window. This one appears to be about 16.5 inches x .5 inch wide. Not sure about one of the shows as that broke off inside the frame.

Do you have this operator in stock? I need a replacement. If you need additional information please let me know.

metal length: 13.5" stamp: 13 9 BSI unknown manufacturer/date 2 needed currently, may need and add'n 4 but of different length.

Window is approx 29lbs. Coil spring - 3 springs each side - #5.5 5". P - 232208 - Aug 04 Coil spring cover - part # 801030 Pivot bar - 3" - seems to be 26-378 from your website? Need help identifying part #'s to place order. Thx

only marking was FK

My jeldwen window needs a 22.4-IPCaldwell part, can you help me.?

I do not see any numbers or part names. It could be that I do not know where to look for them. By googling I was not able to find exactly same looking locks and latches. Want to replace because they are rusty

I need a replacement for my sliding glass door. The handle broke and so I need to replace it. The door lock has the number QC-PASS 537-45 (Rev C) 23/09/12 The holes are 3 15/16. The hole in the door is 1 cm.

Hello, I'm looking for replacements for window handles. We recently purchased a condo from the 60s that seems to have old handles and nobody carries a similar size. There are 2 handles on each window and the windows slide sideways to open them. The holes are about 2 1/4 inches apart, which is the pr ... (cont.)

Hi, my window does not stay open when attempting to open it. The bottom of the balance channels lift off the window and do not provide a snug guide for the window. Its unclear to me if these original guides are the correct ones to use (I recently purchased the house and this window has always been ... (cont.)

The string broke. Wish to replace both sides 22" length. See photos

Hello,Can you help me find this weather stripping for a Norco wood/glass sliding patio door? This is an 8ft strip and the channel that it fits in is about 5/8" wide by 1/4" deep. Please call with any questions.Thank you,Paul

This is a 1964 door. There is a screw sticking outside the side wall that inserts in the door hole. The plastic lock handle that moves the door mechanism inside and moves up and down to lock the door is broken. I am looking for a new hangle mechansim or just the lock switch.

The only markings I can see is certain teed

Hello, The lock on both sides of My single hung window was broken. Could you please help me to find a replacement part?

Are you able to recommend a replacement solution?

Please identify this part (I'm sorry but I don't know the correct name of it) and quote a price if you stock it. Thank you.

This lock is missing The lever. The exterior piece and lock handle are plastic. The overall measurement of the exterior piece is 3- 1/4"..the screw to screw measurement is. 2 -1/2". The mechanism part that moves the vertical lock up and down is 5/8" Wide, I can't tell how long it is without taking p ... (cont.)

Hello I am looking for both left and right side tilt latches for some original gapco windows. This house that I am working on was built in 91. The latches appear to measure 3 3/16" long, 1 1/8" wide and 5/16" thick. With hole spacing 2 1/8" on center. Thanks for all the help.