Viewing all customer Discussions for:

Other

Coil balance has 10 printed on it. The window was made General Aluminum, which is now MI. What part do I need to order? Thank you.

Looking for 4, 29" balance channels.

Hello, Is it possible for you to identify this handle/latch unit? The guys of the handle are good, one of the handles broke off unfortunately. There does not seem to be any brands or numbers on the unit. Thanks, Kevin

I've been informed they are Caradco windows and screens, but it might be wrong. The clips are vinyl and snap into a groove in the window casing.

Hi there, I am in need for a replacement for this roller removed from a mirrored closet door. This is a 1-1/4 inch nylon roller, the housing 5/8 inch wide but the flange is approx 15/16in wide. The housing is 1-3/32 inch high.Thanks!Steve

Just purchased condo, previous owner installed new handles but all operators are failing, cracking and no longer working. I need 5 left and 5 right?.any ideas?

I think this is called the sash pivot bar. I need two please.

Hello, I'm looking for replacement for these channel balance parts. The metal channel is 27" long and ~5/8" wide. The metal channel is stamped with the following: 26-3 HD5 CMC 54. Thanks! Joe

these clips used on false front vanity door. Ultracraft was manufacture, but no longer supports. picture attached.Thanks,Fred

Hi, I purchased 26 channel balances (order #1826587), now I need stops for the top sash corners. They are right and left. Do you have any like this? I need botha dozen left and a dozen right. Fred

I'm looking for a sliding door handle that locks from the outside to match the one I have. The handle is 8.5" by 1" and has a 4' gap between the screws

been looking for these for days with no luck at all

This is plastic beading that goes around the inside edges of the glass pane in our storm door. It is designed to snap into a channel in the door frame, but can removed so that the glass can be replaced with a screen during warmer weather. (The beading then snaps back in to hold the screen in place.) ... (cont.)

thank you for your help. Our home was built in 1989 and has HURD wood windows. The windows are still intact and I am trying to replace the operating part that no longer is working. Can you help me? I see the number 007900 on the arm. Please let me know if you have a part that will work. thank ... (cont.)

Hello Really Helpful Person, Simple screen pins. I'm not really sure of the exact length because I only have broken pieces. They're from a window using TRUTH hardware if that helps. TIA Kevin

Where can I get replacements that won't rust out like these did?

I need 2 of each picture. Can I please have the part #. Sincerely, Patrick

Looking for this casement part that goes on the bottom of the casement window.

Was hoping you could help me identify this top sash guide and if you carry them.

I need to replace a bunch of tilt latch for Loockheed Monarch windows. Do you have anything that would work?