Viewing all customer Discussions for:

Other

Window measure 34 inches (L) X 15 1/2 inches (W) no markings , except for "bonded 99" on outside window frame Window has a "locking device" on left side of window. appears that an "arm" of the device is missing or not working? Thanks for all of your help.

Hi. I just purchased a new home that has Andersen casement windows. I do not see a model number on the windows however most of the crank handles are broken as well as a few of the latches up top that lock the window. Are you able to identify the parts I need to purchase from the attached pictures? I ... (cont.)

Metal roller. 5/8" outside diameter. 5/16" width. Pin size 1/8". Came from Miami sliding window.

I need another kit like this

I have a broken left hand latch. I don't know the manufacturer. It's a Manufactured Home built 20 yrs ago by Champion Homes.

I am looking for glazing stops for an Anderson window. Attached are pictures.

4 1/2" on center of holes

Looking for this screen retainer clips for our vinyl windows.

Hello, I've provided three pictures of the window balances I need. I need a total of ten of them. The metal extrusion portion of the balance is 29 inches in length. I hope you are able to see both nylon pieces I need on the ends and the number on the metal is 2830.

This is a Provia Aspect sliding door. Not sure if I have to just replace the door handle latch or the mortise but was wondering if you carried these replacement parts. Thank you

Looking for parts. I bought a set of Jeldwen white Vinyl windows from Home Depot in 2003. The wen locks/keepers and the (weak) "security locking pin" assembly (plastic tab to allow window to open only 3") all need replacing. The stationary parts are both 2.25" (pair of screws on centre), and the w ... (cont.)

I thought it looks like a certainteed part pivot is much longer than I have seen in other windows

I need to replace the operator for casement window. The house is 20 years old. Could you please recommend the part?

Markings on Balance: 29 5 KW CMC 11 Length: 30 inches The metal clip is not in the photos provided because it broke off.

My top window falls right down when unlocked what to do to repair. Also the bottom window locks to the frame a have broken off need to put new ones in

Hello,I am in need of two replacement window Sash's.The Length is 24" measuring only the metal frame end to end. Thank you lambert

My home was built in the early 1980's and these are probably the original. The only numbers I can find on them are the numbers 004. The present retainers are getting very brittle and need to be replaced. The hole in the window pane for the retainer is 1/4 inch(including the sleeve for the retainer. ... (cont.)

Need to know what part number this is And if available to get

Pivot shoe is 1/2 inch thick, 1 3/16 wide unlocked 1 5/16 locked 2 1/8 tall Pivot bar is metal, a little longer than 2 1/2 1/8 x 1/4 the tip is 1/8 x 7/16 x 1/16 thick and a threaded hole 1 1/4 in from the end.

Please help me figure out what weatherstripping I can use to replace the degraded material on my Alcoa windows. Does Menards or Home Depot carry something suitable? An item number or SKU would be greatly appreciated. I'd like to knock this project out before winter. Thank you.