Viewing all customer Discussions for:

Other

Trying to find replacement rollers and upper seal for Pella Patio door installed in 2005. The door is 500 miles away, trying to find parts before I make the trip to the Upper Peninsula of Michigan. I do not have much more information. House was built in 2005 with new Pella products. I think t ... (cont.)

I'm looking for help in finding this piece to fix my other drawer. Dimension width was about 1 inch inside plastic piece. I don't have any part information other than the table is a broyhill that we purchased new 20 years ago.

I've sent pictures I'm John and I need help

I believe I have a truth window crank, model 30744B. I did not see that model number on the site. Can you let me know if you have an equivalent part. thank you

Hello,I need some replacement window latches. Please quote for right and left side of windows.Thank youTy

This is for a Merrillat bathroom drawer and the plastic part broke on one of them. The guide is 18 5/8 inches long. The white guide is 7/8 inches wide and the metal guide is for 1/2 inch.

The currenct weatherstrip has number 20755 and says entry guard truth. Noyt sure which to buy

DO you have a replacement ?

The door latch handle is stuck n the open position and I cannot move the handle in any directions. The door was installed in 2000 as part of a complete home Caradco windows and doors replacements.I took the whole unit inside the door jam out and found that several small aluminum parts inside the l ... (cont.)

PC41C is stamped on side Cannot find it in any search. Pictures and measured drawing attached

We live in the U.S, but our home is a Canadian built. We can't find markings on the hardware or windows, but they are double hung. There are several rusted or broken pivot bars and we need replacements. The pivot bar is 3 inches in length. From the end to the middle of the first hole is 9/16. The en ... (cont.)

There are two of these per each glass pane on bottom edge.

This part broke and I was referred to you. The sliding glass door is over 30 years old. The part I need attaches to the door frame.

Need to replace lock set

1/2" channel balancer, 21 inch channel length 1-1/8 inch bottom shoe, no ears on either top or bottom shoe Channel stamped with "20 D" and what may be "BSI" (very small) See photos. I suspect I need a 21-inch model 390 / 2040 balancer, but I figure I should ask.

Photo shows one broken and 1 good sliding mirror door wheel/part

I have been in search of a new screen sliding door handle. Local stores do not carry the part in their inventory. My current handle has plastic pegs that insert into the medal frame, and click together through the screen. Two Screws hold the two sides together through the peg inserts. Would you ... (cont.)

The part that is broken has A12 on it. It's the part that goes at the back of the drawer.

Hello, this is from an aluminum storm window latch. Maybe 30 years old. Spring loaded and has a little rectangle cut into the aluminum frame that holds a small piece of plastic to keep it in place. 2.5 inches long. Was ordered through Menards. Trying to help out an elderly 92 year old friend. ... (cont.)

Hi I'm looking for a replacement part for this operator. I purchased the house recently so I have no information on who made the window. It's about 4" long.