Viewing all customer Discussions for:

Other

this is all that was in the track. its a single hung vinyl window. not sure what it is

So the inside gears are warn out.

Need help identifying casement window crank operator for a small window above the kitchen sink. It's a two pane window one cranking out left one cranking out right with each pain 12 x 31" roughly. The current cranks have Entry Guard stamped on them. Are I'd 4" hole to hole.

I have 26" long 1/2" wide balance that is broken that I need to replace. Not sure which one I need to order.

I need several of these drawer stops that are broken on a dresser. I uploaded photos of the part alone and one that is not broken and installed. Please advise as to what specific part I need to order. Thank you.

Need some replacement parts as window will not function properly. It will open and close but when you take out the bottom part to clean etc is where I am having issues getting it to snap shut. Thanks you.

Length 20 5/8" Stamp 20 3 BS1 ? Quantity 2 balances

The crank has broken on one of our casement? windows and we do not know what parts to order. The running track is 27" long and the arms open to 25". The handle crank screws only so far on the broken window so that we can fully open it but can not close it. It does say Truth on the arm. ... (cont.)

Need the replacement for a Jeld-Wen sliding screen pull latch assembly.

Hi, The window is off the track not connected. It's a sliding window that goes up and down. Not exactly sure what replacement parts I need to fix this window but hopefully through the photos you guys can help me out. Thanks so much! Ben

My house was built in 1981. Not sure if these are the original windows or not as I also have Andersen casements in the house too. The identifying number on the back of the latch is 40226. It measures 2.5' by 3".

I am looking for a patio door lock and found this 82-399 at your website. Want to make sure that it is correct.

Need replacement wheels for New Castle xt Sliding screen door. And also how to remove the door from the track.

Need 2; can't find locally. Length with wheel - 3 1/8"; Length without wheel - 2 5/8" Width, part with 3 holes - 1 11/32; Width, smaller attached part - 1 1/8" Wheel diameter - 1 3/8"; Wheel material - plastic Roller has 3 holes on side opposite wheel; 2 flanges on bottom

Do you have the rod that connects to this part? I have a butcher block table drawer. With both ends but nothing in the middle.

I am looking to identify this part and get one ordered to replace for my window. The full metal length of the part is 35 inches. Thank you.

Part to hold rail

What do I need to order this part?

I need the window latch and the safety latch to keep from opening all the way

I need to order 2 parts and I don't know which ones to order. Can you help me please? Thank you so much n