Viewing all customer Discussions for:

Other

Hello, Can you tell me if the photo attached is a Truth folding handle

Have 3 windows all same part, 2 stick and are hard tonopen close. It is a spring with chord combo. Id 2140-d from the pic.

I need to replace two balancers for a single hung Milgard window. Balancer is stamped with 32 3 IT CMC 0 although the metal piece is 33" in length. I'm unable to find an exact match to these numbers. Our home was built in the 2001/2002 timeframe. FYI, the forth photo shows one balancer installed, ( ... (cont.)

I am looking for the bottom wheel assemblies for a gienow 5100 sliding glass door.

Looking for a non-folding crank for this 12-tooth spline. The narrow part of the spline (where there are no teeth) measures somewhere between 1/4" and 5/16" diameter, as measured with manual calipers. The wider base of the spline is about 3/8" diameter. There are 2 sets of teeth with a gap between, ... (cont.)

I need the 4 pairs window tilt latch rights and lefts Then I need the plastic protection covers for the top corner of the window so when you open the window all the way that the tilt latch don't catch .

Attached below is a screen door handle which I need to replace and I cannot find anywhere. I was told you would be able to help and it would be greatly appreciated. The measurement from the top screw to the bottom screw is 6-3/4".

Hello. I think I need to replace the glass in my single sash window. Apparently, that isn't possible without removing the entire structure from the frame of the house? Should I replace the window glass? It seems as though that would be easier than the mess and effort in repairing the interior and e ... (cont.)

HI, looking for 4 of these w/ handles RH. Screw holes about 4-3/4

Need this part. Do you have it?

Needing 2 ea 36" replacement sweeps

Operator looks correct. Wheel to fat Original wheel thinner. No nylon

Looking for 2 pair

Hi! Recently replaced our patio door. Contractor did not install the lock for the screen door. I believe the door is made by Simington. Any chance you can help? Thank you in advance, Rick

I found the imprint 40575 on the bottom side of the operator arm, and TRUTH imprinted on the top side. I am looking to replace all hardware on a left hand and a right hand operator. Including all hardware applied to the window itself. Thank you so much for your help!

Hello, I am in need of replacement tilt latches for my Simonton Windows. I believe the model is FS 55DHWI38.844x16.875. I'd like to order a pair of left and right replacements. Thanks

Operating Panel interlock bracket for Anderson Perma Sheild 3 panel door Year 1986

Need replacement of handle lock. Still functional but cosmetic corrosion and paint flaking.

21 5 KU CMC 6 Stamped (need 4 all uppers) with Clutch Shoes for Vinyl Double Hung Tilt Window.

I am trying to find replace part for patio door handle. Thank you for your help