Viewing all customer Discussions for:

Other

I need two balances for this window. It appears to be a block and tackle type balance

I need to replace this operator. Any idea what part to order?

I'm trying to find the part number for this broken clip manufacturer "Truth" hardware as well as some instruction for replacing it. Photos included for you. Thank you, Jim

Need side and lower weather stripping for a Pella proline patio door

I have a 28" balance shows code 24E PV, 068/255/256/257, looking for the replacement?

I have 26" window balances. One of the balances has what looks like a part number. 25 4 FU CMC 4. The steel measures 26" from end to end not including the plastic. I hope this helps and your able to identify the balances. Thank you, Paul

Marking on assembly 45034 and 1H as well single arm

I just placed an order with you (#1719602) for 25ft Kerf Mount Bubble Seal, 5/16" 58-053. It's the horizontal strip between the lower and upper windows. Can you confirm that this is a suitable product for this? Thanks.

I replaced a 39-032 operator. When window gets close to the closing position, it pushes out at the bottom corner. It appears that a piece is broken. It looks like some kind of pivot or anchor mechanism that keeps the window tight to the frame as it closes. I don't know what the piece is called. Can ... (cont.)

Can I pickup

This part coil in the window frame and are designed to pop out to prevent the window from sliding (opening) all the way. This are uniframe windows.

I have some 20 y/o Roma Therm windows that need new balances and pivot bars. Here are some photos of what I have. Can you recommend replacement parts? the windows do not have cut outs in the channels to take out the broken pieces. Is that something I can cut into the channel? When I order the pa ... (cont.)

I'll need 20 pieces. Tks

Digits found on the part are: 7 27 Part dimensions = 6 ¾ x 2 7/8 x 3/4 " Dimension of window sash = 32 x 23.5 " (I need 12 parts for 6 windows) Thank you.

The handle spindle broke off, need new operator Truth model 45251 Manufacture date I think is 05112006 10:07

5 1/4" long hole to hole.... 3 5/8" center to center hole offset arm.... 1 1/8" wide mount holes center to center on bottom. 5/16" pin hole for E-clip.

Would like to purchase two cracks

Hello. I need to replace a Caldwell 17-4 DQ window channel block & tackle. It measures 18 inches length, 1/2 inch width, and 9/16 inch depth. I have attached photos. Please tell me which part I can order that best matches the Caldwell 17-4 DQ.

It allows me to flip the window over to the other side to clean it

Hi,I need to replace 2 left and 2 right operators. The current ones have 'Wright 6794' on them.I've never replaced one before, do I need any special tools to install/adjust them?Thanks,Jeanette