Viewing all customer Discussions for:

Other

Replacement

Hello, I recently install an American Craftsman 50 series patio door. The lock that comes standard is horrible I would like to replace it with a multi point security lock

No marking. It goes with the 39-430 and 39-429

patio slider door handle broke and I need replacement. It is stamped "sash controls" with the number 2265. The interior handle is wood. Do you have replacement I can purchase?

Ready for any help/ suggestions. Thank you.

Part number 3253106 Date 03/08/13

I have older ( approx 1982) wood framed patio screen doors. The outside handle on one of the doors broke so you can't pull the door open from outside. It doesn't close as tighter as it should either when I close it from the inside. I could not find any part numbers on the screen frame or handle. Ple ... (cont.)

This is for a sliding mirror doors Do you sell replacements Eric

Hi i need 2 operators one left and one right

I discovered that my sprinkler system hitting the window has rusted out the pivot bar. I have not had much success with trying to get the bar removed from the window (screw is rusted) and as you can see the pivot shoe is filled with the rusted bar. I don't see any similar pivot shoe to buy and als ... (cont.)

The window hardware is marked as: TRUTH 30818. I need brackets and screws for 2 windows. There is a left and a right side that both open up. From reviewing your site, it looks like they might also be available in stainless...which would be preferred as these are located on the water in NJ. The salt ... (cont.)

this is where the vinyl window is inserted. one on the left and one on the right to hold window in place

This is the original crank from my kitchen window. The house was built in 1959. The arm that attaches to the gear inside the crank broke in half and is not repairable. I need to replace if possible. Thanks!

The plastic piece broke?.. glue did not work

would you have these i would take 2 of each side left and right. i didnt see them listed. Thanks Steve

Could you please help with purchasing the correct balance and balance cover and also a window tilt latch...thanks

3 inches 15/16 space for the screws

The picture is the lower part. I dont see one on your website that matches. The ID number stamped on it is 27HD. It is a spring loaded balancer.

Hi SWISCO Experts This is a an impact resistant sliding door for a high rise. Please advise if you have this type of handle. Thanks!

Hi do you have a replacement for that if so please send me a link to buy it thanks