Viewing all customer Discussions for:

Other

Need help to identify my parts. Mounting holes measure 2' 21/32 center to center

Hi, I was wondering if you have this pull? My mother said the pull broke. It was my grandmother's hutch and my mother is heartbroken over it.

no markings, no nothing. gear on lifting arm is stripped. arm is one single piece that curves back with a gear on the end. threads on knob are okay. window is at top of garden window box.

Hello-Could you tell me what Top Sash Guide I need for 28" Series 385 Channel Balance I just ordered? Thanks for your help!Bette

Looking for one of these handles.

Hello, I am looking replace this kind of lock for my slide door. Please let me know if you have carry this kind of lock and how much. Thank you.

I am looking for a seal for the sliding door track (to seal the bottom of the door). Can you help me determine which seal this is and if you have it? See picture attached for the profile, it presses into the track and is sort of a bulb seal. I need at least 1 of these 5 feet long, but maybe up to ... (cont.)

No markings, names, or numbers. I need the part to go in the empty slot...not sure what handedness that would be. Measurement between two screws on part that connects to jousie is about 4 1/4". Measurement between two outer screws is about 4 3/4". Between two inner screws measures 3 7/8". Also n ... (cont.)

Nami narcotic 100/200 hi-1, Rating nfrc Series clcase MST 2650 Nfrc HII-1-006-7/14-15 97-M We need replacement bracket for our window above.

The windows are (I believe) window world 4000 series. See attached picture showing window tag. I tried to raise the window and the right side didn't slide well. when I tried to pivot window in the right side was loose and I noticed broken parts on the sill. Is this enough information to reco ... (cont.)

Do you carry these clips for Anderson storm door. Serial number included.

Looking for 2540 stamped replacement

These windows do not stay open and fall down. I am hoping the above helps identify what part is needed for these windows.

On back of bail pull stamped A 9550 D.C.

Can you tell me if you have anything that would substitute for this..... Don't have a factory wheel to measure but the track is .75 inches from edge to edge measure inside by caliper....I have seem similar in your Question and answer but not exactly the sameI would need left and right offset for one ... (cont.)

Not disassembled yet The lock/latch still works but has no 'detent' between locked and unlocked position. Preliminary research into options...cannot find any markings so I may never ID mfr. to find parts. Soon I may have to remove it to measure the mounting hole size, position, etc. Is there anyt ... (cont.)

I am looking for replacement springs for a simonton double hung window. I am not sure the weight of part needed but they are a mess. The sash metal piece is also broken and all of the plastic pieces are also broken. Any help in finding parts is appreciated! Thanks

hi I'm looking for parts for that window and i dont know what brand is is doesn't say in the window but anyway the coil is good the only thing is that small piece from the botton with hold the wind pin is not holding anymore i think ai have to replace the whole thing, do you have any idea if your ... (cont.)

I have Peachtree vinyl double hung windows that don't work. They have Caldwell 3675 AK channel spring balances. The lifetime warrantee went with the Co. Where can I get replacement spring balances that will work work?

I am looking to replace this window crank or at least get a knob for it, which is missing. I have no clue the make of the crank. We moved into the house and there is no paperwork identifying the make or model of the crank. Any advice is welcome