Viewing all customer Discussions for:

Other

I'm trying to replace both window cranks. Left and right side. I can find no numbers or letters on the crank other then the letters "gu". I included the measurements to better help with finding the correct part. This is for a small kitchen roll out window. Thank you for any help you can offer with ... (cont.)

25 year old vinyl replacement window.. the metal recoil in the balance snapped. That helps raise an lower the sash.. I need 4 of them

Hello, I am looking for a replacement shower door seal, it seems to be a smaller version of a shower door seal. Can you help me with this? Thanks!

I need to replace this missing piece for my window.

built in door (cylinder) lock into outside door handle

I am looking for butterfly cranks to replace the ones pictured on Marvin clad case master windows. We need 3 of them. It's so that the shades cover the cranks.

2 1/2 inches long, about 1 5/16 to first hole measured from the round end, the holes are 3/8th of an inch apart, and the bar is 5/16th wide, and about 3/16 thick. anything close to that is fine, I can make it work. Thx

seal bug sweep

I would like to order at least six of these hinges. Please contact me via email as soon as possible to place an order. The door is off of the cabinet an laying on the floor.

I'm trying to locate this part for a casement window in my house. I think it is original to house that was built in 1954 in Okc OK. Sorry there are no marking or serial nos. or manufacturer anywhere on the window. Any help is very much appreciated. Thank you.

Can you recognize this extrusion in your parts inventory? This lifting strip snaps onto the glass at the bottom of the pvc window--if there is too much lifting friction, the lifting tab(that runs the full width of the window and the mounted end is shown by the pencil) break off....making further lif ... (cont.)

Hello My drawer glides on my century furniture are all broken. I took a pic of the one good one we have. It measures 1 1/8 x 5/16. At this point, I would take any suggestion you have. Thank you. Brian

Long arm, 10 1/2 from middle of 40254 plate, 30472 RH on back. 4 1\2 on short 20544 with clip.

Hi. Needed to order the parts for my sliding door. Can you advise which products I need to order?

Window balance Markings 86 17-3 cc5 cmc 54 - IWC window

Good evening. Can you please help me to find the right window balance for my windows? I need six balance. I include the window size with a vinyl frame and single template glass to calculate the weight.50" 1/2 x 30" Thank you

I'm looking to find a replacement door handle that locks like the one in the picture.

Need two lefts and two rights.

40164347/03 23.6250. 637500. 55RH L2AG. y00077/2/18Need two plates and three crank handles for our crank out windowsThank you Sue

I need 14pcs of 6' Snap-in glazing material. See attached photos. Windows are 20 years old and the window company is no longer in business. There were white aluminum mullions to provide a paned look removed from outside of windows. I had to remove all surface pieced including the perimeter, which ha ... (cont.)