Viewing all customer Discussions for:

Other

Hi. Took these photos before seeing your website. Window is currently open about half way, won't close. If this enough info for you to suggest a replacement, or should I take more pics and look for a brand name and model number. This is for a rental house so will need to make appointment to go v ... (cont.)

Old pocket door

I was not able to locate this weather stripping. Please provide ordering information. I appreciate your assistance.

Please inform the dimensions for the clip, I need to figure out if the clip can fit in the place available.Thanks,Steve

Original window from my 1999 condo has both broken top latches. What would be the replacement part for this? Thanks!

Please help me identify what I need. This is from a impact window. The sash is about 36 lbs. the metal part of the rod is 30". The rod is stamped 29DS 38 BSI. I will need 6 of these. Thank you, Joe

Hi: My Milgard aluminum doors has 28 years and they have a drain flap and it is broken. Are they replacement parts for the drain flaps? Where can I get them? Pictures are taken at the bottom of the door from the outside.

Here are 3 pictures of the handle/lock/mortise. I cannot find a brand but I think i need 82-310. Can you confirm? Thanks!!!

Do you sell window keepers in this style? The screw holes are 1-1/4" wide and the piece is 1-1/2" long. I purchased the 90-005 Window Sash Lock 2-1/4" and now need a keeper.

Your photo of style 380 is closest to mine. Stamped on my piece is 25 4 and BS1 My length of channel is 25-5/8" My base shoe is 1-3/8" long overall, 13/16 on the rail and 9/16 below it I need 2 each

Gentlemen,I have 4 page installation instructions dated 12/6/71. House was built about 1975.I want to buy two replacement assemblies. Want to be sure I am getting the right parts. Right now the door is re-assembled, but if more information is needed I can take apart again.Rod

Need to know the proper replacement part for the rollers

2 1/4 x 1 1/4 x 9/16

I am told this window crank is a TRUTH part. Please advise. Thank you!

I have searched far and wide for this desk drawer lock. I only need a new one because the desk came without the key. There is a number on the face of the lock B180 but I haven't been able to cross reference the number anywhere.

Need replacement crank and cover

BSI window channel Balance 2990 38 E Need 2 replacement sash cams.

The handle base has bent and torn probably from being slammed too often. It no longer locks. I am trying to find a replacement. The door was purchased in 1999 from West Coast Plumbing in Arcata, CA, whose owner, Tom Hopkins, recommended asking you for help. The patio doors were made by Insulate Door ... (cont.)

Hi,I just received 30 window balancers from you and installed them. They all work great.However, while installing them, I found some broken parts/laches that I would like to order from you, but I don't know what they are called and the exact part I should order. They are all the same. It's the top v ... (cont.)

Part removed