Viewing all customer Discussions for:

Other

Hi, I'm trying to identify the listed window balance

Please identify replacement balance. Existing balance is 34" long. Only marking is the number 3330 stamped on the end. See photos

Our drawers are 22in and the cabinet is over 23in from the face to the back. Trying to find soft close replacements since these are over 15yrs old. Attached are photos with the measurements and of the current sliders. Thank you.

Hi! We're remodeling our kitchen and misplaced some of our knob backplates. These were originally antique brass with no texture. The house was built in 1981. I need either 5 or 12 as close to these as possible.

Please help to identify

I think it's called a block & tackle balance.It's the spring bar mechanism on the sides of my windows; to be able to pull up and down smoothly. I'll need 10 ( for 5 windows)Pictures attached with the weight of the windows; all about 30 lbs/each.The markings on the bar say:33 5 60 Caldwell.Appr ... (cont.)

Hello, I'm looking for this Truth casement operator and sash mount bracket and bronze handle and cover. It has a single arm with 2 step downs in it. I believe it may be 176- Entrygard Dyad. ? Thanks Tom Janik 2156518305 Also I am going to send some pics of door hardware I need at the same residence ... (cont.)

I included a hand print of an old balancer. It looks like it might be your 28 series 351 channel. But the window sash is 20 lbs exact so it might be either the "2730" or the "2740" to cover the window weight. I live in AZ so these windows don't get opened so when I needed to, the window balancers ki ... (cont.)

wind damage photo is taken from similar window

I have 7 windows I need balancers for. Five of the windows have a stamp number of 2940 (BSI) on the aluminum rail and are 30" long and 1/2" wide. One has a stamped number of 1730 and is 18" long and 1/2" wide. The last one has a printed number of 29 9 FS CALDWELL and is 30" long and 1/2" wide. I ... (cont.)

Hello, Looking for some replacement roto operators for aluminum casements

I need Harvey Closet sliding door rollers. With 3/4" offset. The rollers are ROUND. Thanks

Trying to find suitable replacements for these casement cranks. Only have these photos as reference, i know its a long shot but i was hoping somebody may be able to match them based off these bad photos. thanks for the help

I am looking for the parts in the attached pictures. They mount on the window and allow the sash to be tilted in. Any help is appreciated.

1 1/2 spacing in screw holes

I need to replace this part. I need the part number and price for this item Thank You Joe

Hi, looking for replacement 'cleats' if that's the right word for them...this part anchors one end of a spring and, no surprise, the plastic eventually snapped under the tension. The measurements of the cleat are 2 + 7/16 (L) x 9/16 (H, at tallest) x ½ (W). Pulled from the channel of a BiltBest A ... (cont.)

Side Window track

Weight of windows is 19.6 I do not have the length of the balance or an undamaged balance.

I'm trying to fix/replace my window balance springs and cannot identify the exact part I need. I'm not sure of the weight needed to support the window sash.