Viewing all customer Discussions for:

Other

I have a Thomasville Bachelor Chest that I am Restoring.One of the pulls is missing. Any help that you can give me would be greatly appreciated. Thank you.Sincerely,Pam

I can't take the door off to look or take pictures (cold out).The roller assemblies are mounted on a metal piece that goes the length of the door,the metal piece also is the bottom w/strip.the rollers are about 4 inches from the ends,the ajusting screws are about 4+ inches long The roller wheels ar ... (cont.)

I need a set of corner keys for the window. It's the window that slides up and down & is hooked to the pull down screen. The provided picture doesn't really show the corner key.

one arm stamped 40762 and one arm stamped 40761 and 21221 is stamped on back. US Patent #4,241,541 PLUS, I need the crank handle and decorative cover. HUGE THANKS!

DID NOT REMOVE DOOR NEED ANOTHER PERSON. ROLLERS NEED TO BE REPLACED. lABEL ON FRAME HAS THIS INFORMATION: SERIES 332 SGD SD-R50-1816X2426 (72X96)

Hi. I would like to identify the handle portion of my window pane unit since the old one is broken. Please help. THank you.

Looking for just the sash insert for a inside storm window for a mobile home. From edge of frame to frame it measures roughly 28³/? in. By 27 in.

This is in the bottom of a sears Vinyl window. There are 2 of these perWindow. 1Screw hold it in place in the bottom of the window.

Need to get a total of 8 of these markings look like 33 4 CS?

Andersen 1361356 1361461

I need help to identify the correct operating mechanisms for two of my Crestline replacement windows installed in 2003. Window description is provided in photos. The operator arm has Truth 31850 on it.

Need to replace the pins? On the window sash the go into the spiral tension piece, this is a tilt window. The pieces that I need to replace have rusted off.

I have an older Glass Bi-fold closet door. The guide pin is binding on the track because the guide roller broke. The spring stop also broke. The only part number I could find on the closet door is the Acme 17-4405 corner block. My condo apartment was built around 1980. Thank you. ... (cont.)

Door operating very heavy and adjusting rollers ineffective. Roller appears similar to your part #81-158 but tabs shown on top of casing not showing on your part 81-158 (which I have ordered this am). Have I made an error or will 81-158 work for my door? Mark Tooth

Why do some sashes do not have the clips and how to take them out

hi,one of the above latches is broken and i need a replacement . would you have the part? i don't know the brand.neil

hello. These top and bottom rollers come out of our sliding doors which are approximately 35 years old. the bottom roller is 1&1/4 in diameter, and the top roller appears to be 1&5/16ths. My mom doesn't remember what brand the sliding glass doors are, she said "maybe peach tree". the top roller look ... (cont.)

2nd posting. I forgot the photos on the first one. I believe it is a S395 but not certain. Length = 28" Weight rate = 2730

I believe you have mentioned part number 36-045 in one of your posts to match the casement hinge as shown. Is that correct? If so, how can I order a pair?There are also other Truth Hardware very similar but slightly different, such as both arms meeting at the same pivot instead of being attached to ... (cont.)

More than 20 years old, door on Pella patio slider. Can't find any tag or marking on the door itself to figure out the model