Viewing all customer Discussions for:

Other

I have a broken part from an aluminum commercial window. Non tilt. It fits in the track and sits below each end of the window. Is this called a shoe? The plactic part measures 1 3/16 across and 2 3/8 length.

looking for plastic ornate molding on drawer face

Looking for matching vinyl glazing bead.

Need 2 replacement balancers for bottom sash. Pics are of top sash balancer. I don't have the bottom balancers so can't send pics of those - should they be same as the uppers? Bottom sash is same size as upper. I need supplies for full replacement: balancers , guides, clips, rivets, rivet set tool, ... (cont.)

This is from a condo I own its the lock to a slider.

3"long 1/4" thick I see a 3 and an L for markings

HelloI am looking for parts for multiple locking pInt window hardware. It seems to be a Truth concealed . The only part I found in your catalog is the retainer # 39-456.Can you please let me know if you would have that sliding part that is moving up and down when you operate the handle.Thank you!Bes ... (cont.)

I have a sliding patio door and the weather strip needs replacing see photo. On the glass I see the following info etched: PPG Herkulite K CAN/CGSB 12 1M 16 CFR 1201 C11 ANSI Z 97 1-2009 1/8UA SGCC-250 Hope you can help!

I have a patio screen door that appears to be missing both it's corner pieces and rollers, per the attached photos! There is what looks like an adjustment screw on the top of the frame pointing down and is visible in the photo labelled Door1. Can you please identify what corner/roller combination I ... (cont.)

These are pictures of the coil housing pivot parts from Prism windows possible 10-15 years old. Wondering if this is something that is still available to repair or replace. Thank you. Gregg

Hello, this is the DSH50121 model, I WOULD LIKE TO FIND THE SAME4IDENTIC TO BE ABLE TO REPLACE ON MY SLIPPERING DOORS

I am looking for Anderson storm door window retainer strips and cannot find the ones I need anywhere.

Looking for a white left Jeld Wen sliding window handle as shown in the above pictures. Thank you. Diba

The end of the handle actually goes into the hole, it does not wrap around a knob. The tip that inserts might be about one half inch in length or less.

I need to find correct part# for 2 Sizes of window balances both 1/2" width but one is 27" long and the other is 15" long. Measured just the metal piece not the two plastic fittings on the ends.

I can't seem to figure which model I need to replace the broken piece.

Hello I am looking for replacement drawer sockets for my kitchen sliding drawers. They are rear mount . but have this distinction on back side of socket . that matches 2 holes inside back side of cabinets its self. Not screws are used to secure them. They snap into place.. Thank you in advance ... (cont.)

Patent No 5701636

I need help identifying the replacement part. These are approx 7/8" wide, 2.5" overall length, maybe 1.5" hole to hole. Thanks for the help.

looking for a replacement crank for a window. I attached some pictures.