Viewing all customer Discussions for:

Other

Hi. This is a weather strip for a crank out window we purchased from Wellington windows in Minnesota , now out of business.I hope the photos are helpful.Don

I already used 17/32"(part#15-015) but it was a little thick, that's why I ordered 1/2"(part#15-046). Am I right with this one or I am wrong again. Please help me with right part. Thanks.

Can you please help me out with these. I work for Oklahoma department of Veterans Affairs and I am needing some replacement parts 13 ? 20" left hand drawer glides 19 ? 20" right hand drawer glides 6 ? 20"x 5 ¾" left hand drawer side 10 ? 20" x 5 ¾" right hand drawer side 4 ? 20"x8 ¼" left hand side ... (cont.)

I probably need to replace all my screen retaining latches as shown in the attached pics. Installed in my condo around 2000. They seem brittle and expect all of them to break when I remove my screens. I have 5 windows. Please forward any info on these latches and windows. Thank you Jan ... (cont.)

This is a Peachtree casment window thirty years old. Double glazed. Hinged left from inside. 30" x 48" worm drive gears worn and causes too much movement in wind. Also the bar to upper left of gears also worn and has too much play. Any hardware that would work will do.

I need coiled balances for 3 lower sashes. please forward item numbers I need to order. Thanks Frank

We need 2 sets of 27 3/4" balancers 4 sets of 33 3/4" balancers 6 bottom pins 1 window latch Please see attached photos

I need a dozen of these please. Description from Sexaur says 23 inch x 9/16".

Need new 2 sets of new balances for my basement windows

Plastic trim

Need to find this part

Replacement sliding window rollers. CCirca 1978. The channel is three-quarter inch wide and a half an inch deep. The broken piece of plastic base is 1" x 3/4 inch. The roller measures 1/2 inch Diameter and 1/4 inch width. The axle hole in the middle of the wheel is 3/16

It looks similar to the liner i found online, only with a spring tensioner instead of a balance. Can you identify this? I only know that it is not a Marvin EZ tilt. The liner measures 54" on the long side and has an 8 degree bevel.

Hi- The stamping on the coil is "832". What coil and weight number do I need? The windows are single hung, tilt out windows. Thanks you.

This is an internal lock on a sliding glass door. Are these enough pics to help you determine the lock I need?

Want to replace door handles for FOREVER VIEW storm door, Hardware resembles Pella Mortise Lever Handle set Product code 40-199

Hi, What parts do I need to change this to a keyed lock?

I need a replacement slider with these numbers found on the one that was still in place.

I ordered what I thought would work but I was wrong, this is what I need. My original order was part #38-209. I couldn't get it to snap into place. Yours has serpentine ridges to the inside of the forks the one I took off another window has a small shelf running the inside of the fork from one sid ... (cont.)

No markings on doors or glass. Approximately 23 years old. Company that it came from out of business.