Viewing all customer Discussions for:

Other

is your wrench for Pella windows

Need 3 pieces that customer threw away. Need 2 pieces 27 3/4 and 1 piece 43 1/2. No name or tags on window. Measures 1" wide total. Section over glass is 5/8" and section that slides into retaining groove is 3/8". Almost flat in appearance.

Hi Believe to be andersen pn 1521604 Do you have anything compatible? what is the return policy if doesn;t fit?

The latch is missing on my daughters sliding door. Center to center us 3 1/2"What replacement would you recommend?Doug

Need replacement part for Anderson windowHouse built in 1980The part # is 60 P 719117

I believe Alcoa is the manufacturer. The windows were installed in 2013. It's 1"x 2 3/4". Stamps on inside of latch: AN 8300-02 8301-1 8313 002

This part is broken and we want a replacement We found a sticker on the door it says CONFORMS TO CGSB 12.5-M86 Type 3C ANSI Z97.1-1984

It most closely resembles the Certain teed coil balancer by dimensions. The band is 3/4" thick. The pivot shoe is 1-1/4" wide. Over all length looks to be about 4-1/2".

I just purchased a house with all double hunts that need several locks replaced. Do you have these crestline locks?

I need the Correct part to replace.

Hello we found this balance in a window it only has strings in it I have a picture of what the strings come out but we don't have any idea what kindof balance it is if you could please give us a idea of what type of balance it is I would really appreciate it! Thanks

Can you help me identify the keeper I need? The building was constructed in 1980 or so, if that helps. Thanks!!!

I need to replace to channel balances on a window that is 34" wide and 59" tall. The window that slides up and down is counted in these measurements. Separating the window out it is 34 inches wide and 30 inches tall. The channel balance in the window now has the markings 27 3 on it and 158 - 7B (not ... (cont.)

These clips hold in our wooden grates. Window Technologies is the manufacturer.

I haven't been able to find this part.

Little square nylon spacer or Guide On the side edge of the window sliding frame.

I have a sunporch that has 7 North American windows (various sizes). The window seals are in varying stages of decaying. On a couple of windows, the round foam part has come completely off. The seals are on the bottom of the window. Hopefully you are able to see the 3 photos I uploaded. Are you a ... (cont.)

I measured with ruler, see photos, the top width that slides into window metal is one-half inch--The pivot is 2 piece, that arrow tip slides into the main piece with the tab that secures the window sticking out--I sure hope you can help. Thank you, Lou

Hi- we have a bunch of window cranks that have broken. We previously had a handyman replace, but the part was too small and flimsy. it looks like your product would be a better match. i have attached pictures of the original crank. I also wonder if the thread is too worn down... the product that l ... (cont.)

Length is 29" Width is 1/2" Markings 28 2 LS CALDWELL Manufacture of Window JORDAN Single Hung Non Tilt Windows