Viewing all customer Discussions for:

Other

I am trying to figure out which wool pile is needed to replace the worn/missing wool pile in my windows. I believe they are Ideal windows but I am not sure. I attached pictures of the wool pile from the window in the 4 pictures. I already purchased 13 rolls of Gray Pile Weatherstrip, 7/32" x 5/32' ( ... (cont.)

I removed the existing door by lowering it enough to push it off of the black threaded hanger bolts shown. I disposed of the door with the receiving brackets still mounted to the top of door. I am in need of a similar top of door bracket to prevent having to dig into this any further. ... (cont.)

Casement window parts. Please let me know if I need to have a count of which way the open out and how to correctly identify that part..

I need quantity two for my Loft Window. Markings = 27 4 KT CMC 4 length of channel = 28 in Thank you

Looking to replace / order this part

Truth Part # 45136 rh

Hi, The lock which goes into the frame is broken. It's a Better Built window. The window slides up and down and tilts. Please let me know if you need additional information.

Good Afternoon, I need to replace some springs from a few windows. The above photos are the parts needed. The one labeled D has a 6 stamped on it. I will need to replace both sides so need two parts. The one labeled A has an 8 stamped on it. I need 4 of these for two windows. Can you let me know ... (cont.)

Markings large "V" below it "A" also need 2 latches #82-107

15" channel balance off of a philips window. 4 little dots at base of rod

Hi, I have two screen doors that open to the side. Where the screen doors meet in the middle the strips of plastic help seal the opening and not let flys in. Can you please let me know what part should I buy to replace it.

Hi I have a Larson door which had a bad lock. I damaged it while removing it and need the Mortice lock assembly plus new handles and trim The door has reg # 025982U 111980507 Hopefully you can Identify what I need to order Thanks Bob

Handles for windows

Please let me know if you have these

Plastic bracket/socket broke on drawer. Slides are cream colored, Blum w/ 220E500 , -11-16 stamped on them. 7/8" x 3/8" x 19 3/4". White plastic socket has 60.1961 stamped on it, and it is about 2 3/4" long. Assuming cabinets were installed in 1986.

Do you carry the replacement window regulator to replace the one I need as shown in the images attached??

The pivot bar is broken

I would like someone to help me identify the replacement part number for a Tilt Latch for my window. Also if someone could tell me the model number. I have attach photos of the sticker and Latch to be placed. Thank you Jim

I need to replace my patio door mortise lock, but the part that covers the latch is also broken. Is this called the keeper? The replacement ones I'm seeing online are flat, but the one in my door is not. What should I be searching for to find a replacement part?

Hello,I discovered this broken piece on my non tilting window that wasn't working properly. The metal part is 33" long not including the plastic pieces on both ends. As you can see the insides are old (house is about 20 yrs). I may even consider replacing the same piece in the window on the othe ... (cont.)