Viewing all customer Discussions for:

Other

I have some 1996 semco casement windows that the latches have broken the nylon piece inside has deteriorated I need approximately 56 latches will this latch you describe work the same as a semco and is the inside still nylon or are they of aluminum

What is the plastic piece the sashes slide up and down against

I need replacement cranks for a few of my windows. Almost all are right hand link the one shown in the pictures but I do have a couple left. These windows were manufactured by Bass Window & Door in Princeton FL but the have been out of business for over 20 years. Please give my your part numbers ... (cont.)

The window slot is 9/16ths at the lip and widens to hold the housing to approx 10/16ths. Wheel diameter is 23/32nds or possibly as small as 11/16ths. Depth is approx 1in. Original was likely a steel bearing. West coast Florida, likely PGT Windows approx 1982.

I am looking for the tilt pivot for a Sears replacement window. Probably installed in the 80's. Vince

Balance length: 29 1/2 inches Balance stamp: ULTRA-LIFT5 LB 29-50 LBS Balance color: gray Quantity: 5

I need to find parts to fix my handle. Thank You

This end cap goes over the balance where it screws into the frame. I don't know the name of it, but I need one. It is 2" long and covers a 3/8" spiral balance.

I'm looking for a replacement sweep for my framed shower door. I included 2 pictures.

I have a few window latches that are jacked up and need replaced and I'm having a hard time finding them at Home Depot or Lowe's I believe they are 2 11/16 by 11/16 if you can help me out I would greatly appreciate it

I need a screen sliding lock for a BF Rich that is out of business? Please find the attached pictures and let me know if you can locate them. Assume a left and right are needed. Thanks

I'm looking for the pictured guide. There are on top of the moveable windows and screens. I have several broken off.

I am looking for the roller for the glass window. Two pictures of the same roller are shown.

I have 5 (five) 40" double hung (double tilt in) windows. We installed them new in late 90's, we think. The bottom sash on one window has a bubble seal on it. As near as I can figure, it is 58-156 for replacement. However, the other 4 windows do not have the side opening where you would slide the pa ... (cont.)

I have a Lexington single dresser # 336-22 and need replacement parts. The drawer stop on the lower drawer has broken and the drawer falls when opened. The first photo (3317) are the broken plastic stops, 3316 is the part they broke off of (I believe) 3315 is the track on the bottom of the drawer it ... (cont.)

Looking for Silverline/GU Split Arm Operator (Right Hand) and also the part for different window as sent in picture. Thanks ! Heard your finding parts for customers is fantastic

This is my broken bracket. Kind of looks like32-025. What do you think?

Where can I buy a replacement for this part?

11/4" X 2" plastic

Hi. Trying to locate a replacement (right side) tilt latch for my mother's window. There is a NAMI label (see below) but no manufacturer references to be found. From what I can figure, it might be an Ellison window, but I can't find a part number or identify a source for a replacement. Anything you ... (cont.)