Viewing all customer Discussions for:

Other

I need both sides of the window. Springs broke on both. The part number in catalog is 96cq-36RH and left hand also. Note the 6R on the casing.

Hello.. looking for replacement parts, photos attached. Thank you.

Hi, hopefully you can help me out. I have been looking for the replacement of the window crank assembly,the arms are fine. I have been searching for this brand,Truth, replacement parts with no luck. Any information, advice or guidance is hugely appreciated!

Can you replace this

Channel series: S390 Channel length: 44 Channel stamp: 4350 Quantity: 2

My window would not stay up so I removed the two channel balances. They are marked with 23 9 BSI. The metal channel, not including the plastic parts, is 24 inches long. The width is 1/2inch on the front with the writing. The side width is 5/16inch on the side of the bar . I am looking to replace the ... (cont.)

From what I gather this would be a 19 and 5/8 or 11/16, 1/2 inch channel, wings on the top and shoe. Best guess would be the 385. Also which length 19, 20 or 19 5/8 or 11/16? The window weighs 25.5lbs which is above the 1850 stamp option as well. One has markings of "19 9 BSI PV" the other "19 9 ... (cont.)

Hi I've been trying to find someone with comparable parts. I can't find the original manufacturer. The part number I am looking at is 32-e-50 Your S350-32 looks like my balance. Do you know if they might work me? Thanks for your help.

Our KK window crank broke off and need to replace the star inside the handle. Do we need to replace the whole crank mechanism?

this pivot pin is 2.5 inches long with 6236 stamped into underside.

When I took out the bottom window this spring came out of the bottom latch the spring is 1 and 1/2 in Long. I need to order one.can you tell me where it go because I can't figure out where it go. I know it came out of the tilt window because when I took out the window a screw and the spring and lac ... (cont.)

I took a picture of the numbers I found on the part but can't seem to identify which one it is. Can someone please show which balance part I can buy to replace this one. Thankyou

Paella sliding door. Screw holes are 7 1/4 inch.

Hi, is there a handle only for part # 39-045

need 1/2" wide channel balance. # 630. do you have? thanks

I am wondering if you sale this part. Thank you

Hi i have an d Stanley entrance door that swings in that i need to replace the door sweep.and the door sil/threshold or just to replace the black rubber seal that goes in the slot on the threshold thank you

Both right and left

Those are installed to my window by the company who build the house on 2001, many of those parts are broken and the windows does not stay up

The plastic insulation has become brittle and broken. The plastic is an extension of a wood piece that gets screwed into the frame to hold the doors in place. Would you have replacements?