Viewing all customer Discussions for:

Other

I can't seem to find the type of window balance

No visible numbers, windows from the early 89s id say. Theres a US Patent # engraved which is 5620213

Says 29 3 ES Campbell on them

my customer is wanting (1) per the attached pic.Gene -Thank You

need two balances for this window

Hello, I am in need of 3 sets (6) Top Sash Guides for a PGT Single Hung window measuring 35x48. These 3 windows do not currently have the top sash guide so I'm not even sure how to identify what I need - are you able to assist or need more details? Your attention is greatly appreciated!! ... (cont.)

Looking for the replacement window

Hi, I need to replace a channel balance - the only marking I can see reads "25 5 IS CALDWELL". After reviewing the site, I'm pretty sure that I need a 26" Series 385 channel Balance. I'd appreciate any input.

i need to relace a couple of these can you help me thank you

I have 23" channel balances that have the markings 23 5BSI R with a half moon after it. I would like to know what the right unit would be for my application.

I am looking for a replacement part for a roller on a Stanley sliding mirrored closet door. Any suggestions?

The tilt latch part is 3in X 7/8 in and I desperately need four of them. After reviewing your inventory I didn't see any parts that fit. Screws are two inches apart. I hope you can help.

Plastic bracket at back of drawer hardware to hold slider in place. Existing piece has a large G with the numbers 6020 6 and either RH or LH after the number. We have located similar items but they are not large enough for the drawer hardware. Need opening approximately 1 inch by 3/8 inches. Th ... (cont.)

Our Transom window opens when cranked but when trying to close the window it stops closing even when cranking closed. It appears that the threaded ring piece on the crank arm holder is not seated properly in the hole. We have a second transom window and the threaded ring piece is seated within the ... (cont.)

Hello,I'am trying to identify and replace the hardware pictured. There are no logos or markings to identify the make or model. I see from previous postings that the markings on the glass has no connection to the door hardware. Any efforts to identify the model and where to purchase would be appreci ... (cont.)

1.5 inches front to back, 4 inches high n with the metal stop on front 4.5 inches in height

These assemblies are 26" long not including the plastic ends. The only identification I can find on the metal channel says "25 4 CALDWELL GM".

There are no marking on this at all. It comes from a slider probably from the 1990s. It is held in place with the ears on each side which set in a slot on the door. Would it be possible to just replace the wheels if the whole thing is unavailable?

Hello, can you identify the top and bottom part. This is a 24 inch long, 1/2 inch wide B.S.I. # 2320DG. What is the proper replacement part from Swisco? Thanks.

Can you tell me what part I need to buy? The window coil has come off the part and no longer slides. The Part number is 5,353,543 Please see photos