Viewing all customer Discussions for:

Other

It looks like #90-278 matches existing lock (see photo) however I don't seem to find a similar keeper. What do the experts think?

non keying flat spindle

I need 6 - 8 of the 2740s and at least 12 of the 2730s. I can send the old ones is that's easier.Thanks,David

I need this lock for the active door, but customer wants to change the one for the inactive door, are they the same mortise style?

Hello, attached is a bathroom simionton window balance assembly /The assembly broke and the window will not stay open or grab.I will a complete assembly for the full window.There were no part numbers to reference.Please help and thank you for your assistance.If need to call please do. ... (cont.)

Hello Customer Care , I have about (12) "Bilt-Well" double hung wood windows installed in the late 50s. the windows are all slightly different but most are 8 over 12. I can provide all sizes if necessary. I think the Bilt Well window company of Dubuque Iowa is no longer in business but may ha ... (cont.)

I'm writing to find out which of your products would be the best fit for our old window operators. The only marking on the inside says "FUTESA." I've attached some photos here with measurements- please let me know which would be the best match, along with any hardware we may need. Thank you so much ... (cont.)

Hi! Looking for 2 windows coil balancer thanks, Jay

Looking to replace this guide block for latching bar on two crank out windows just old,brittle. Need four

Hi.... These are on a 3/8 tube balance, 28" long with a 30" spiral rod. The sash is no more than 20# which might correspond to a "red" type balance. I need either just these parts or a complete unit. Thanks Much, Bernie

My AconDorwal handle has broken near the screw. My door slides left to right so the handle is on the left side of the slider. I purchased a replacement but I think it was for a door that slides right to,left. Can you help me find the correct replacement ?

Looking for a replacement channel balance for a Jeld-wen window. The balance has "27 4 CV CMC 7" stamped on it.

I purchased two balancers from you, S385-33, option 3240, and installed them. Now I find that a small plastic piece on the window that engages the top of the balancer is broken. These are photos of the unbroken piece. Do you have this plastic piece?

Wondering if you have a kit that includes all the required parts to replace our system. Thank you.

Distance between mounting screws 3.9? door thickness 1.45-1.75. Face dimensions 6.11?h by 2.047?w. Handle project 1.909. Center to center 3.9?. Please help me find door sliding patio lock from outside.

Hi there! I need help identifying the missing door handles please! Unfortunately I can't find the parts anymore. Thanks and I appreciate your help! Lily

My name is David and I need help with getting a part for my simonton double hung windows. I believe the part is called a pivot shoe and is a flimsy plastic piece that helps the windows open and close smoothly. Not sure of the part number but the above picture has one of the serial or model numbers s ... (cont.)

I need to fix several windows where the balancers popped out of place. We were quoted a crazy amount for each window. My windows tilt. Balancers are stamped 27B BSI TX or TK. Length is 27? and width is .5?. We also have 27C BSI TK or TX.

The straight piece in the picture with the ruler snapped off the piece on the underside of the window frame while opening the window. This is the right side open window (as opposed to the left). The first picture is of the left side window from the top that shows how the set up is supposed to be. # ... (cont.)

Is it possible that you have this sash guide? Its a left and right guide.