Viewing all customer Discussions for:

Other

I recently purchased item #82-086 but need a latch assembly that works with it... I have attached two photos of what we have now but looking for the ability to key lock it from the outside ...all that is there now is just the latch Thank you

This part sits on the top of each window section and when released, the section of the window is able to pivot into the home. Both sides of one section are broken and the window falls open unless it is locked. Without the sliding tab the length is 2 7/8" or 7.4 cm, width is 3/4" or 2cm ... (cont.)

Could our 26-116 window lift work on your window? Have a look and let us know.

Pella double hung window locks

The sticker says Keystone 5500 Looks similar to your part 82 265

Casement window does not work Need a left hand mechanism

We are looking for a window crank for our home. Yhe house was built in 1910, this is an original window and the crank housing has cracked as seen in attached photos. Any help would be greatly appreciated. Thank you in advance for your help. Chasidy

we have several hundred window screens that use these corners.the tops have a hook that holds the screen in the frame so i would need a left and right,the bottom ones do not.there is a flat edge around the outside of the center piece that has broken off of the one in the photo.THE CENTER PIECE IS 7/ ... (cont.)

2 piece 28" long approx .75" wide I need the plastic part that releases the asrracal The plastic piece hooks the medal strip to release the pin so the door can open

I am wondering if the trim parts pictured here are replaceable or if I'll have to replace the windows? The windows say Gapco on the latch. If these trim pieces are replaceable and available, does the trim come in cut-to-fit lengths or are they available per window? Please let me know if you need any ... (cont.)

This is the opening mechanism for a window in my very old house, I'm not sure how old the part is but I would love to find the same one somewhere. I uploaded pictures of the markings on the part, let me know if I can help in any other way.

I need four bottom guides for the bottoms of two sliding shower doors. Thank you,Eric

This came off my horizontal sliding window. Two per window on each bottom corner.

This seems to be a hinge manufactured by Hettich. The numbers on it are 652 300 5500 and 503 200 80 00 and 137 and 36 2

Looking to find replacement for this pivot bar . Please help . Thanks Scott

Pivot slide pin for Harvey window

Looking for replacement locks for awning windows. One of these is a Marvin (not sure which). Could you identify these, installed around 1993. I need a set- left n right- of each. Do you carry these parts, how much would they cost? ThanksNick

Hello - My broken channel balance is inscribed with BSL 28300 (but the last zero looks like a backwards D). I suspect your comparable replacement part is Series 380 Channel Balances 1/2" x 29". Can you confirm? Thanks, Darec

Hello, Trying to find a replacement for the attached balancer. It says its a Calwell 20 3. Length of the metal is 535?? (21.06") which does NOT include the plastic parts. From my research of your website its either a 380 or 385, but I'd appreciate some professional confirmation! Please let me know ... (cont.)

I need 2 left balances and 2 right balances and 2 pivot bars. Each balancers have a 5 lb coil on the top and a 4 lb coil on the bottom.