Viewing all customer Discussions for:

Other

In need of 4 balancers. 1/2" width, non tilt. 29 3/4 length 2975 stamped on side. Can't identify the top and shoe to determine series. Please help!! Need ASAP. Also found on side DS1 60.

I need to replace the rollers on my 32-year-old Acorn sliding glass door. I've attached a partial scan of the installation instructions that give the series of the door as "DorWAL Insul-DOR SERIES 800"; panel 6A identifies it as Roller assy PN 8001 and the sketch on panel 7 may help in identifying ... (cont.)

The clips have broken off completely. I had two windows blow into the house last night during a storm because they are no longer secure. I need to find replacements from a reputable reseller asap! Found these on two other websites but you're company looks more legit...just can't find the part on you ... (cont.)

Please advise if you can replace exact or similar

Need this item which I believe helps the window stay up. It is missing fromthe other side. Please help me identify.

The operator on my Anderson casement window (installed mid 80's) is broken. A part number that I see on the arm is 1361316. The window swings open to the left. Can you provide me with the appropriate replacement part. Thank you,

Hopeful you have the plastic corner that joins rail sides of our sliding glass door screen. Thank you!

Good morning, Attached pictures are of the old roller taken from the bottom (right side) of the door. Thanks.

I need to replace two of these. They are on the inside the window channels at the top of both sides. They seem to be a stopping point so the channel balance stays in the channel. They are attached to the channels with two screws.

Please tell me which is the right part to replace this window balance

Australia 2018 8 Universal street Eastlakes

Attached is the picture of one of the windows I have that won't stay In place . Please let me know if you can identify the parts needed

Hello, I have a broken channel balance and from a similar post I believe it is a swisco part. Could you help me identify the correct replacement part number? Please let me know if additional pictures are needed. It is 27" The identifier stamped on the part is 26 4 CV cmc 7 Thanks! Gabriel ... (cont.)

Hi!My coil spring was broken, so I looking the replacement for the coil balance, but I can't see any number shown on the spring and no weights on the window, I weight my window like 10 lbs. So, I should oder the S190-540? Or S190-940 for both sides? Thanks

Hello! With the attached photos, I need help identify my window weather stripping in the picture, if you have it or do you offer something in its place? Channel = 3/16th" wide Brush = 3/8th" wide

Is this the same as your crank unit? WYNN 55

Need to see if I can get parts for lock and latch for summit glass slide door that was put in 1991

Need to identify a correct replacement, please. The metal component is 27 inches long. 26-4 CA2 CMC 7 is printed on the piece. It seems ok except for the broken cord. Can just the cord be replaced? Thx!! Ed

Looking for a replacement for spring stamped 27 2 FW CMC 11 -metal is 28 inch long

I need a replacement for an 8" Truth Hinge for a window that is 26 x 29.5