Viewing all customer Discussions for:

Other

I am looking for this replacement part for my sliding door. Will you please let me know which part to order? Thank you.

Need both left and right spring loaded roller. The closest I see is the Paniflex center spring loaded roller, all the dimensions are the same except the location of the roller (center) instead of left and right

For residential tilting windows by ACAN. Installed in year 2000. I need two of each.

This photo shows the style we need...I believe the windows are AMI made around 2002. Measurements are 2 5/8" by 1/2". please advise to availability and cost

Hi. I am desperate for help. The mechanism to open and close my two bay windows broke. The handle doesn't crank. The arm seems to work but I dont know exactly what I need replaced.There is no names or numbers or markings found anywhere on the window to help me figure out who to contact. ... (cont.)

Drawer slide broken. When I slide the drawer out, the drawer falls. Need to replace the plastic piece underneath the drawer

Off of a Simonton thin frame sliding door screen.

Hello, I am hoping you can help me figure out what I need to buy in order to replace my sliding glass door handle and lock mechanism. It was broke recently during an appliance delivery. When put back on I realized I couldn't move the latch. Upon removing the handle etc I noticed the latch was snapp ... (cont.)

Need 2 roller units- look pretty standard- 1inch steel wheels/ about 5/8" wide, 3" longjim rollers have been cleaned, lubricated, and reinstalled- door works lots better but I would still like new tollers

There are no numbers located on any parts. The rod is 28" from metal to metal. There is a color tip on one end, appears to be orange but could be faded red. 'The windows are old aluminum windows installed new in new construction in 1980.

I need the inside latch so this part locks for a screen door

4 - 28-3/8" length 18 - 24-1/4" length

Im not sure if the windows are jalousie or Awning. They are quite old and have no numbers on them. They are all aluminum and I would describe them as stacked awning windows. The panes are aproximatly 2'x3' and there are 4 stacked. My quick measurements for the operator: 1. The two bottom hole spacin ... (cont.)

Not sure of the manufacturer. UNI-k-5 on the sticker

Serial # on the back: 06262003 1312

hi, i am looking for the right balancer for this part. there is only one other number mentioned on there which is 11600-17. but in other posts it was said, that this is a generic number used on many parts. thx for letting me know!

Looking for part for replacement. Ordered this from swisco a few years ago but do not have part number to re-order. Thank you.

I need 7 of these. I see the name Truth EntryGard and the numbers 30818 and 20748

This is an upper sash balance. Part number 5.737.877. The plastic part at the end of the rod is broken and does not stay in place.

want to know if you have replacement window lock for jeld wen v4500 series