Viewing all customer Discussions for:

Other

Hi I need some crank handles and covers for Kolby Koby Windows built in the mid 70s can you help me

Hello I was hoping you could help find a replacement for our window slider lock. The spacing between the screws holes is 2 1/8 inches. I see you have other with a little larger spacing but would prefer not to drill extra holes. I am looking for 6 units. thank You Michael

Looking for one of these. It says Wright 2 on the back

Need to replace 15-20 window operators I have Wright 7701 on my windows Thanks

The hinges currently on my cabinets are original with the house, so about 20 years old. They are not standard, so the ones that look similar at Home Depot, Lowes, Ace, etc. are not the right fit. Can someone please help me find replacements for these hinges. The original ones are starting to fall ... (cont.)

SNE Enterprises Series 976 HS 2003 Would you have 3' glazing bead to fit this window? Thanks.

I am having trouble identifying the replacement for my Andersen balance. I see either B1441336 or B1441335 stamped on the cartridge. The visible glass is 16" high and 20-1/4" wide. Which balance do I purchase.

Hello,I'm in the process of buying the channel balances Product code S350-29 (2830). I also need the Top sash guide but I'm not sure witch one to buy for my windows.Please see pictures. Thank you for your help. Property is in Puerto Rico and we are still recovering from huracane Maria.Francisco ... (cont.)

These parts are from screens from an Alliance double hung window. I need 4 of each. Can you tell me where I can purchase? Thanks for your help.

Need upper n lower tracks, rollers for top n bottom. 60" width.

I need 39" window balances for heavy kitchen windows, as you can see from pictures above #3850 is printed on it. I found this here: "39" Series 385 Channel Balance, Product Code: S385-39" and I'm guessing to choose stamp option 3840, regarding sash weight range. I'm not sure this is correct however. ... (cont.)

i am try to locate a spiral balance that is 1/2" in diameter over all / 34" long with a black tip for a tilt sash - any recommendations?

Safety latch - 2" longNeed 24 of themThank you. Bruce

I have 3 windows that have the same problem. I think I need your part #15-192 in its entirety. I am not sure exactly how to install them and was not allowed access to view the video. When I clicked on the video it said it was restricted. What do you suggest? I need to replace 9 more windows but if t ... (cont.)

My windows are 30 years old. Some of the sashes are broken and the locks do not keep the windows tightly closed. Below is the only information I have on the windows. "Wenco JX-7 Premium Tilt is equipped with sash tension set screw in pivot block and Jam Jack adjuster for fine-tuning sash tuning o ... (cont.)

23 5/8" length. Code stamped on it is 23 S 33

Hi, I need 2 balances like this. Can you tell me your part #. I also need lower left side(looking from inside)jam.

Hello, I was informed by a CSR at your location that you could help me in finding a replacement for a wheel which no longer works on a sliding door (manufactured in the early 70's). I believe that the roller I need is similar to product code# 81-071. I have included several pictures of the roller ... (cont.)

Hello Athan,Take a look at our 26-318 pivot bar. This should be a good replacement for yours. Thank you!

I am looking for a replacement coil for my older vinyl windows (circa 1995).The coil is stamped 440. Is this something you carry? And if so, would you give me the part number/name for ordering. Thank you.Rosemary