Viewing all customer Discussions for:

Other

Hi, The 29? long channel balances were stamped with 2820 or 2830. The 25? had 2420 and I guessed that the same height window with six panes that was missing its balances was 2430. The sash guide I ordered matched the dimensions and screw holes of mine. The 18-064 is smaller than mine. Thanks! ... (cont.)

These latches are a slightly different shape than the ones on my windows. Mine measure 2 ¾" from the screen frame to the end of the latch where one grips it. Also rather than having two tabs to go into the window channel mine have just one curved tab. Do you have another version or will these fit? ... (cont.)

What do you call this window tilt mechanism?

Attached are pictures of the ends and name of my window spring. Please help with identification.Thank you!Robert

The sliding part inside the window is what has broken I?m trying to find the replacement parts, but I?m not exactly sure how to get the correct ones. Any help would be greatly appreciated.

OK, I got the patio door roller kit (81-266) and it looks like I should be able to rebuild the rollers on my patio door with the parts in the kit. The only issue I have is what to use to create a head on the headless end of the "brass" roller axles to secure the axles in the brackets. It appears I n ... (cont.)

I'm looking for a shower door sweep that has three screws to attach to the door. My old one has a grey plastic sweep. Do you have anything like that?

need window operator/crank for alside ultramaxx vinyl kitchen casement window.

Could you tell me which replacement I should use

Need help. California builder 1994

have a knape&vogt side mount drawer slide #1260 we need a end mount for this slide. I think its K&V KB1304 if I am reading the # right. Its very hard to see. ( i need 2) thanks

Numbers on balance are: 25 9 IV CMC 7 Do you have in stock & shipping time to Hollister Ca 95023 need 2

How much need 10

were can you buy it?

Hello, I?m hunting a replacement for a drawer slide socket that has broken. The up-turned angle of the socket pictured makes it difficult, most replacements that will fit are flush with the drawer sldie. The back inch and a half or so of the slide bends downward. Slide is ?bottom mount? slide ma ... (cont.)

Is 26-241 the correct replacement part for an Appleby window pivot pin? The measurements from your website appear to match the original part (length, width, thickness and hole placement to center of holes) but I am not sure. Thank you

The springs are attached to the lower window by a plastic part which broke. Need to replace the springs and plastic parts and the metal attachment to the windowAre there install instructionsGlass interior measurement is 27 5/8exterior width 30 5/8exterior hieght 31 3/4peter

I have a casement window that doesn't crank open or shut .The number on the crank arm is 07800 .What do I need to fix?Wendell

Length of metal is 24 inches. Is there more info you need in order to find a replacement?

Thishandle from casement window is about 50 years old. I have many handles where the knob at end of handle has broken off. There are no markings that I can find on hardware or windows unfortunately.