Viewing all customer Discussions for:

Other

I'm looking for plastic takeout clips for 10 year old Plygem single hung windows.Your metal clips won't work. Thanks

Had a repairman come out who was a bit of an argumentative fellow. Not very detail oriented or willing to share his expertise with us. That being said, what he did share with us was we need Alenco - 2 sets- bottom rollers. Door is 48.5" wide. I can tell you that the home was built in 1983 if that he ... (cont.)

I need help in ordering the right window balance I have an Atrium non -tilt window the metal on balance is 30" long welded sides 1/2" wide

I have 3 floor to ceiling mirrored closet door panels that are 4 1/2 ft wide. The rollers on them are only 2 yrs old and are bent and cracked (probably from the weight). Do you sell metal rollers.

Drawer pull for chest of drawers yk451

I have a Lexington dresser World of Timberlake and one of the dresser pulls is broken. I bought the furniture in 2001.

Hope you can help with getting the right part. Window installed in 2003 . Non-tilt single hung.

Pls advise what bracket # to order and use.

I have a fifth wheeler with sliding bypass mirror doors. I ordered the correct part from Swissco

Looking for 2 drawer pulls for my ninghtstand. My bedroom set is the Bellasera (Thomasville)

need to replace the center lock on mastic windows installed in 2001 they match a picture i saw on your site with 2" on center installation holes, words mastic on front

I purchased an F-10 French door from windows doors and more in 2000. One side has a door knob and deadbolt. The other side which is fixed (can be open but not with door knob) has the receiver for the door finger and the dead bolt finger. The finger slides through a brass plate with a hole in it whic ... (cont.)

I just obtained some Stanley/Monarch 24" mirror bypass doors from a friend, and I haven't framed the opening for the door yet. How do I size the opening for a set of bypass doors?

I need the piece that accepts the sliding screen door on one side of a center meet ( astricle )

looking for non adhesive weatherstripping...270" backing x 460" pile..Do you carry this? Thank you..

Hi there, I'd like to order some of these, but don't know what its called. Will I need the exact same size or can we substitute? Thanks, Debbie

Trying to identify the tilt latch for a replacement window. see photo.

Attached are 2 photos. The dimensions are hard to read, but 1 15/16" tall, 1/4" wide, and 3/8 deep with a 1/2" wheel. It looks like a Slide-Co# 17239, but not sure. I would like to purchase 10 of them for all the windows that are failing in my [old] house.

These are very similar to your tilt latch 26-266 and 26-267. These are a little larger however. The width at the wings is 1 5/8" and the length not including the spring loaded part is 2 13/16". Any thoughts?

The one on the left is one of your 15-195B shoes that I recently purchased for another job. The one on the right is very similar however in side profile, the portion that locks in to the channel balance is not as deep. I plan on trying one of these to see if it will fit, but since I was snowed in I ... (cont.)