Viewing all customer Discussions for:

Other

Looking for a bar and associated hardware that is attached to the frame that locks the window.

this is 5/8 across the top - 11/16 down the side.

This door lock no longer works. Do you have a replacement that will work?

Bottom track. No shorter than 4' Please. Thank You for everything!

Hi can you identify the replacement pivot shoe for me please ? I sent a picture and the number on the part is 505C. I was on your site and I need to buy replacement spiral balances, and my pivot shoes seem less than ideal. The metal component has come off ( though I was able to put it back ) but in ... (cont.)

Hello....I need a sash pivot bar that I can not find on your site. It is 2 1/2" long with one hole 1 1/2" from the end. It is 5/16" wide and 3/16" thick. The metal is shaped like a "U". Do you have something like this? Thanks!

Hello, Is the subject info. enough for you to identify the correct replacement part? The channel is 1/2" x 1/2" and is 24" long. The shoe is approximately 1 1/16" deep. The shoe and upper plastic piece are both winged. Thank You Very Much, John

Looking for replacement knob for our church bathroom partition door knob. Previous knob was labeled "hadrain". Looks like you have two parts that might work. Part # 10-556 and 10-562. What is the difference between the two?

I have a customer needs ten (10) pieces of Window Balance 5240. Measurements: length 52" Using digital caliper: height .615"; outside rail .599", inside rail .529" Please find attached pictures of the ends. The other side does not have roller/broken.

Has CMECH stamped on inside.

Hello, I am trying to locate this bronze weep cover.

My windows have a 30" tube length and 3/8 dia tube. I do not see a tip on any of the windows I checked, what color should I purchase?

Hi. These are pictures of drawer guides for a JC Penny dresser purchased in 2014. The drawers have a center glide. I think these guides go on that glide somehow. They are plastic and they broke. There is also a stopper in the front of the glide, also brown plastic, which also broke. I sure hop ... (cont.)

Good day Madam/Sir, I would like to ask you for help to get my 20 years double hung window to work properly again. I have three this type of windows and one of them doesn't work. I tried to get parts in Toronto but with no success. I found your web page searching on internet and I hope you may he ... (cont.)

This house was built in the 1960's and I need to find new rollers. Do you have what I need? I guess I need a front-door roller and a back-door roller.

Have a large window with two side load springs with the only marking being 2640x27.on one of them. Evidently someone replaced one of them at some time because they are not exactly alike. I want to order a pair. What do i order. Photos attached

I am looking for the plastic clip as shown in the photos for upper tilt window tube balance. The above plastic connects to a 5/8" tilt tube balance. The bottom of the half of the window tilt tube balance is connected to a clip very similar to your series 600 pivot clip.

This ancient storm window is 3/8" thick outside width. The spline is so old & stiff I won't be able to reuse it. Which part would you recommend to replace the spline? Thanks!

I am looking for a latch assembly for a sliding door. It is a double latch lock. Not 100% what the manufacturer of the door is but on the handle it says JW. Overall length is 12 and 1/2 in from Center of bolt hole to bolt hole is 12 in. If you can help me find this latch and handle assembly or somet ... (cont.)

Retraining clips for top and bottom of a Pella crank out window.