Viewing all customer Discussions for:

Other

Hello, I was wondering if you could help me find a balance system for an older (probably early 80s) Andersen window. I was able to pull back the top plastic casing enough to snap a pic of part of the balance part #. I didn't want to take the entire window apart because it is a rental property a ... (cont.)

inside framework and catches the door when closed

Hi I have been trying to get a replacement wheel for my glass patio sliding door.

Don't know what the parts are called but the pins that go through the screen frame to hold them in the window frame have broke don't know where to go to replace

Number on window: Series- DH 31X Double Hung Type- VSDH Code- TRI- N- 62

I'm sorry the original part was thrown away when the wrong replacement handles came in. I didn't know until I got home around 6pm. I found of the exact part that I need. I hope this can help. Thank you

I am trying to replace a coil that came out of a Certainteed vinyl window. It measures 3/4" wide. It only as #10 and 'J' stamped on it. Any ideas on what to order.

I am looking for replacements for a MW window. Pivot lock shoe with markings 590csb on it. It is appoximately 2 1/4 long, 1 3/8 wide, 5/8 thick, all give or take 1/16. I plan to use your 26-366 pivot bar with them. Thank you.

Hi, I am Rosalind, Manager of Glenwood Apartments in Greenwood, MS. I am looking for the window lock for the following (see attached picture): Series: 450-650-850 WINDOW These locks are located at the bottom of the window and lifts/snaps up to open.

looking for pivot bar like one in pic for acan window

I have 8 windows, of which 7 of the balances are in need of replacement. These windows were installed in 1987 and are in excellent condition with the exception of the balances on some of the windows. Two questions ~ first, there are three different window widths 2 are 44", 4 are 40" and 2 are 38" ... (cont.)

Boreal left and right hand window stops

Can you help me Identifying this pivot cam for me . I'm having a hard time figuring it out

This off of a 2002 43' Mainship pilothouse side sliding door, this is the top roller set . I'm unable to match these anywhere .The lower rollers appear to be model 81-090 units. Any help would be appreciated .

I have a friend that needs new balances but when i tried to take them off I had to take off the lock then with needle nose pliers pull the balance down in order to get the window out. Is this just a cheap window or am I doing something wrong. And yes I used the hold down clips.

White color crank with handle

Handle turns but opener doesn't

I have a Caldwell Balance 31" long 1/2" wide with a mark on the steel "30 3 Caldwell GM". Which replacement part do I need? Thanks

I am looking for a double hung window lock that also acts as a finger lift. The keeper screws down on the stool. The finger lift spring latch screws to the face of the bottom rail

Looking to replace sash balances from older single hung, non tilt, viking 9300 windows 3-10 by 5-10. Length of balance metal housing is 30". Is your S385-30-2950 a good replacement?