Viewing all customer Discussions for:

Other

Want to replace current slide with soft slide

pivot shoe brokrn in slide channel left side

HI, I'm replacing the block and tackle window balance parts to my up and down window. It looks like the 29 " Series 380 Channel Balance will work, but I'm not sure if the plastic part on the top and the shoe is the same. On my old track, its broken so i'm unable to match it exactly. Any tip to dete ... (cont.)

I would like to order these balances, what do numbers mean?

Have a 26" tackle balance from a M W Dual double hung non-tilt window installed in the early 1980's in South Carolina. The top balance is riveted to the aluminum track and bottom slides into slits in the track. The plastic clip in the photo anchors the rope to the bottom of the window. Looking fo ... (cont.)

Do you have Pella door and window parts? Is there a place on your website to look at those parts and order them by Pella part# . . . because I have many of the part#, but only the empty plastic bags with the part# on them. Thank you.

need to find a replacement drawer guide or socket for a Vaughan- Basset dresser purchased in 2002

Hi , We need the bottom track and new wheels. The photo is is one of the existing wheels. The track was removed to install new tile and must have been thrown out inadvertently. The door panels measure 24 inches x 72 inches. We have two panels. Thank you. (I am the home owner, I have contracted a ... (cont.)

at this time I dont have any numbers. At first look I didn't see any names or markings on the window. Hoping you will recognize by photo

we have double hung vinyl windows. Made by Simonton made 4/14/09 1CWM PR-00 ss bottom 2NHS 1LR WH 00 i8 PPDHWI22.063x171750 i0185 085479300600100000 Can you please help us find the type of weartherstripping to match. The stripping is so disintegrated when we touch it falls apart. On bo ... (cont.)

I have a non-tilt PGT window that I am trying to remove because the channel balance is stuck. I have watched a couple of your videos and as a result was able to successfully remove the channel balance on the right side. However, the one on the left side still stuck (see photo). It is stuck on t ... (cont.)

Wheel assembly or wheels and latch I measure the wheels and they are 2 inches by 5/8". This house was built in 1997. I saw the exact window latches from these windows on your site.

Milgard window balance

Our home was built by Beazer and used either Alenco or HR windows. We have 4 of the window locks that have broken and we need to replace them. We ordered 4 of the 90-309 locks from you (which we will need to return), but they did not work because of the high lip on the part that goes under the win ... (cont.)

I

This 30 degree bay is from 1992. All 6 windows balancers need to be replaced. All 6 balancers are marked 11600-17 on the face. The 4 outer smaller window balancers are marked 627 on the mounting tab, the 2 center larger window balancers are marked 1031, also on the mounting tab. There are other num ... (cont.)

Hello, please see the attached picture of the broken piece. Is there a way to fix this? Do you have any instructions on how to fix this, or any local handy-men who can do this? Any information is appreciated. Thank you, Lorna

Length is 2-1/4", width at non-roller end is 3/4", roller end is 9/16", wheel is 1-1/2" diameter wheel, height at roller end is 1-7/16"

Photos include the numbers stamped on the balance. The length (not including the plastic end pieces) is 15". As near as I can tell, the shoe measurement is 1 3/32".

Have a balanced with 33 3 b61 rn stamped on it. Which balancer replacement should I get