Viewing all customer Discussions for:

Other

D/M 3137026 A/S 30S7401 (see attached photo)

I need to replace the bottom part of a Patriot window that recently cracked.

have a Traco Tilt Latch that measures about 5/8" x 2.5". Can u pls suggest a replacement?

Looking to replace old worn out window coil balances. Our windows were installed in a new house in 2003. The manufacturer of the windows was MWWindows who were later purchased by PLYGEM in 2004. The coil itself is stamped with the number 7 on it. Several of the windows had a serial number ... (cont.)

Can't find these and I need to replace them.. Help? Thanks!

I HAVE WINDOW PART NUMBER IS (NAMI A-151-1-51) SERIES NO 3722/3732 HS-R25 I DONT HAVE PITCHOER OF THIS CAN YOU HEALP ON THIS PARTS

your equilivent to a 30310 balance.

I have the Door Flush mounted Key-Holed old "DNS 16 Flush Mounted, Pull Handle", Question Will the 28-00k replacement version work also can I pay for this item using a visa pre paid debit card...

Can you look at my sliding patio door wheel and tell me if this is yours Please see attachment Please make sure the wheel fits over your stainless steel track repair that will be ordered with it. The track I will be putting the repair cover on is .1874 or 3/16" wide which will be the inside dime ... (cont.)

You solved my top roller problem. Many thanks!! Now I should order a few bottom rollers, in case I need them. See photo, for your recommendation

I am looking for a counter balance for a MI window that tilts in. As you can see in one of the photos it has a marking of 35C tBSI. It is the 450/650/850 aluminum series

NO MARKING FOUND

Looking for replacement window balances, channel with spring marked 28D USB, clip at end has wings, 29" long

I have a Jeld Wen window balance I need. See attached pics. Unique 26.5-D-40. 1/2" wide 28" total length.

Attached are pictures of my Milestone single HungSeries 1000 windows. I need the part that holds the glass in place. It is 33.5 inches long and 1/2 by 1/2 inches wide. I hope your have a part that will, I could trim a longer piece if you have a little longer. Thank you. Charles C ... (cont.)

My window is not staying open, I would like to replace the entire mechanism for both side, please take a look at the pics and advice parts needed to buy.

Not sure of brand

I am repairing many screens in Albuquerque, N.M.. I have need for 5/16" straight cut screen corners that are either UV resistant or metal. Can you help out in any way? The usual ones disintegrate in the sun here.

I need several replacement sliding window top guides and can't find on your site. Is it possible to text you a picture of these? I don't know the window manufacturer and these are relatively old non tilt windows. They are approx 1 inch wide and 7/8 long. Thanks for your help

This hardware is heavy duty. Weighs much more than what I might get at Lowes. I hope this helps. The doors are 120" high - a 4 panel and a 2 panel. Standard 6 5/8" between mounting screws. Overall length 7 1/4" I'm just concerned about the part in general. The extra hook and the dumm ... (cont.)