Viewing all customer Discussions for:

Other

PRODUCT OF DEL MAR ENG. CO LONG BEACH CAL PAT 3.670.357

if I gave you the serial number of the windows could you be able to use that to tell me the product to buy from you. most jeld-wen windows

please look at these pictures and tell me if you can source this. I believe the windows were manufactured by Philips.

HIDDEN HINGE MOUNYS TO BACK OF DOOR AND EDGE OF FACE FRAME

Dear Experts: Please help me ID this window balance: Used with Milgard big window. Side loading, Channel Length: 27" Marking: 26DS (BSI) NK 36, BSI is small and sideways. The top and bottom fittings are attached above. Thank you very much for your help.

malta thermal center pivot egress window shash 63 3/8 indoor mesurememt

I think I am ready to order my replacement balances but I don't know the the 4 digit number option correlates to. I don't have the original balances so I don't have any serial numbers to work from. Just trying to match what used to be there. Can touch tell me what that 4 digit number means? (Beginni ... (cont.)

pivot slides alside model #114-150690

I have 7 Kolbe double hung windows and I need new weather stripping 125-05 Loose 36 X 20 DH HK LO E WhT Clad I also have 1 small window 125-9 Loose 20 X 20 DH HK LO E PAT 62WHT

Hello, These windows are aluminum, double pane and are approximately 30"x50". The roller is in a nylon carrier that is about 11/16" wide and 1 3/16 long with a screw hole at each end. The roller itself is flat brass and 3/8" wide with a diameter of about 1/2". See picture. The windows have a sin ... (cont.)

Screw is 1/4 in diameter and 5/8 in length below the shoulder. Course thread (5 turns looks like in the 5/8"). Shoulder is minimal (about 1/16"). I need about 20 on them. Thanks!

this is a large window - the moving panel is roughly 36x36?. One of the balances has broken hardware. The balance is 1/2 x 28 7/8. These are galvanized metal. There is a number stamped near the bottom, but it is hard to read 28D? followed by 3? Also, what is the best lubrication to use on these b ... (cont.)

there are two of these one on each side if i put a screwdriver into the part on the bottom and turn the mechanism it releases the tension .

Replacing the Stanley sliding door top roller kit 00-5024

Hi can you tell me which part number this would be exactly thank you

I need window catch flush mount 2in. Ressest it is for feldco window and has latch on each side.

I have to replace the old one . handle is broken and I need a new set this is the number 0893

looking for replacements, not sure of model.

looking for a weather shield snap on crank

inside the window exterior are support springs that need replacement