Viewing all customer Discussions for:

Other

This lock lever failed after 2 years on the above patio door. I believe you may be able to provide the part. The slider is made by asheindistries. The door is model 8900. Please advise so I may order. Gerry Paradiso

Markings say. HDW Designers Inc. Pleaseantville NY. 352P White plastic

Hi, I hope you can help. We have a handle that the licking lever broke in half The numbers on the one pic attached is the only know information No one in this area has a clue to the maker. I also included a close up of what might be s logo on the handle. It is 5" on hole center. Thank ... (cont.)

1935 casement w/grills Series 4500 Multipoint L white Window is 20 years old and need a whole crank assembly. Thank you for your help. Evan

Hi - I've got Pella windows, probably from the late 90s or early 2000's with broken sash pivots. I can't find a replacement that matches these.

Hopefully, the pictures will help you to identify. The lock is broken (or mechanism "soft" so that it can lock by slowly sliding into that position. i have been locked out!

Good morning. We're a glass company in Southern California and we've stunbled across a customer who needs new channel balancers. I found your logo sticker on a balance and the part number 29C. I also need 26B. If you can provide these parts, I'll need 4 - 29C's & 6 - 26B's. Thanks for your time ... (cont.)

Any suggestions to replace this lock? It has key access from the outside. Regards, John

I am needing to replace the bottom rollers but need to be sure to get the right roller for this door. The receipt from Lowes show item number 41278 (28255) and description above in subject.

This mechanism clips into the lower door channel. It is held in place with one visible screw from the outside. There is a hole in the vertical channel so that a screw driver can be inserted to adjust the door height (and skewed angle). There is a little rectangular hole on either side of the vert ... (cont.)

as stated, side roller arms, springsteel back, with plastic receiver sleeves connecting everything. problem! weight cracked 1 plastic receiver causing collapse. i need to replace the plastic ends, or the springsteel and plastic connectors. 17 & 3/8th between rails. the plastic connector is abou ... (cont.)

i need a replacement for inside push handle for a pella storm door #081505 90838 9835

My windows are 1988 Andersen double hung windows. Which counter balancers do I order? Thanks

This is a vinyl window purchased from Miler Rhymer co. st.Louis Mo.

There are 4 of these white plastic, roughly 1-1/2 inch square, that hold a swinging shower door in place. 2 are cracked, door fell out. Looking to replace the set. Can you help?

Can you tell me what the correct part is for this. I'm trying to fix a window that will not stay in the open position. I've replaced the pins but this piece would not move freely up and down in the track. Any help you can give would be greatly appreciated. Thank you

Part has D-179 Stamped on side. Rollers look to be plastic and are no longer round. I have 3 mirrored sliding closet doors on 2 tracks. Doors lift up to be pulled out. rollers on bottom. 2 rollers on each door I was able to remove roller assembly from its casing which is held in on bottom of door f ... (cont.)

ser#144289. Need direction for a solution.

What is the difference between channel balancer FA2830 and FA2840.

Can you identify this awning window operator? I need to purchase three of them. Thank you