Viewing all customer Discussions for:

Other

Only marking found is a number 5 in a circle

Double hung window sash lock replacement. Looking right and left side.

replacing spring balance in old window

need to replace this but I'm unsure which one to buy

Hi, i have a 30 yr old Stanley dresser that 1 drawer needs totally new slides. They 2nd drawer need the missing back part.

Hi, I'm looking to purchase a replacement of the item in the photos. It's from a sliding door that was probably installed in the early 1990s. It's about 2-3/16" long, 1-1/2" wide, 1-1/4" deep. Any help is appreciated. Thank you, Ari

Good morning, Do you carry this particular window crank or something comparable? The windows are pretty old. I will need 2 of them. Thanks for your help.

Hi, I ordered and received this replacement latch kit. I was able to use it with the old stem. The new stem (key) was too long because this is a keyed door. Do you have a kit with a shorter stem? I'm not sure if the old stem will last. Thanks, Bill.

Hi - I would like to buy new channel balance for my non-tilting window. Some stats: 1. 1/2 channel width 2. 30 inches in length 3. There are markings, it says: 29C USB thanks

I need a sliding glass door handle with 3-1/8 spacing between screws

Hi, I'm looking for a replacement for this part. It's the sash pivot on both sides of the window. The one in the picture is broken. Is 26-423 the correct part? Thanks.

I need three of theses

Pleas help my drawer broke...

The doorhandle on my slider glass door looks outdated. I'd like to swap it out for a newer black handle.

I think the part may be called the coil balance shoe for a vinyl window. It appears that the one in the window photoed above is broken or locked into place at the bottom of the sash. Can it be removed and replaced?

I'm looking for a standard keypad controller for a Roto motorized insula-dome skylight.

i have a simonton window with a broken part, as seen in the photo

Series 152 Coil Balance 10bs coil

Please advise if you have a replacement handle. Mortise lock and inside parts are fine. Outside handle has a broken screw receptor. Thanks

I need new arms. I can see on the current arms. Entry Gard. top looks like 755. bottom of arm look like. 30242R??? I think I need part numbers: 39-031 and 032, 39-107 and 39-205 Can you confirm please before I order. Thank you